Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Example of Diagnostic Display 1. Diagnostic display initiated through ignition key sequencing. 2. Long Pause Short Pauses 3. Code 32 3 2 4. Long Pause 5. Code 61 1 6 6. Long Pause 5B 7. Light remains on at end of transmission Figure 5B-35. Diagnostic Display. After the problem has been corrected, the fault codes may be cleared as follows. 1. Disconnect the negative (-) battery cable from battery terminal, or remove the main fuse for the ECU for approximately 1 minute. 2. Reconnect the cable and tighten securely, or reinstall the main fuse. Start the engine and allow it to run for several minutes.

The MIL should remain off if the problem was corrected, and the fault codes should not reappear (codes 31, 32, 33, and 34 may require 10-15 minutes of running to reappear). The following chart lists the fault codes, what they correspond to, and what the visual indications will be. Following the chart is a list of the individual codes with an explanation of what triggers them, what symptoms might be expected, and the probable causes. 5B.27