Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System Fuel System Fault Codes The ECU continuously monitors engine operation against preset performance limits. If the operation is outside the limits, the ECU activates the MIL and stores a diagnostic code in its fault memory. If the component or system returns to proper function, the ECU will eventually self-clear the fault code and turn off the MIL. If the MIL stays illuminated, it warns the customer that dealer service is required. Upon receipt, the dealer technician can access the fault code(s) to help determine what portion of the system is malfunctioning. The 2-digit blink codes available are listed on page 5B.28. WARNING: Fuel System Under Pressure!

The fuel system operates under high pressure. System pressure must be relieved through the test valve in the fuel rail prior to servicing or removing any fuel system components. Do not smoke or work near heaters or other fire hazards. Have a fire extinguisher handy and work only in a well-ventilated area. The function of the fuel system is to provide sufficient delivery of fuel at the system operating pressure of 39 psi ± 3. If an engine starts hard, or turns over but will not start, it may indicate a problem with the EFI fuel system. A quick test will verify if the system is operating. The codes are accessed through the key switch and displayed as blinks or flashes of the MIL.

Access the codes as follows. 1. Disconnect and ground the spark plug leads. 2. Complete all safety interlock requirements and crank the engine for approximately 3 seconds. 1. Start with the key switch off. 3. Remove the spark plugs and check for fuel at the tips. 2. Turn the key switch on-off-on-off-on, leaving it on in the third sequence. The time between sequences must be less than 2.5 seconds. a. If there is fuel at the tips of the spark plugs, the fuel pump and injectors are operating. 3. Any stored fault codes will then be displayed as a series of MIL blinks (from 2 to 6) representing the first digit, followed by a pause, and another series of blinks (from 1 to 6) for the second digit.

See Figure 5B-35. b. If there is no fuel at the tips of the spark plugs, check the following: 1. Make sure the fuel tank contains clean, fresh, proper fuel. a. It’s a good idea to write down the codes as they appear, as they may not be in numerical sequence. 2. Make sure that vent in fuel tank is open. b. Code 61 will always be the last code displayed, indicating the end of code transmission. If code 61 appears immediately, no other fault codes are present. 3. Make sure fuel tank valve (if so equipped) is fully opened. 4. Make sure battery is supplying proper voltage. 5. Check that the fuses are good, and that all electrical and fuel line connections are good. 6.

Test fuel pump and relay operation as described earlier under ‘‘Fuel Pump – Service.’’ 5B.26