Section 5B EFI Fuel System Flow Chart Diagnostic Aids Diagnostic Aid #1 “SYSTEM POWER” (MIL does not illuminate when key is turned ) Diagnostic Aid #3 “RUN/ON” (MIL remains while engine is running)* Possible causes: 1. Fault codes which turn on MIL when engine is running. a. Code 21 - Engine Speed Synchronization b. Code 22 - Throttle Position Sensor (TPS) c. Code 23 - Engine Control Unit (ECU) d. Code 31 - Oxygen Sensor (shorted) e. Code 34 - Fuel System (permanent adaptation at limit) f. Code 42 - Engine (Coolant) Temperature Sensor g. Code 43 - TPS “Auto-Learn” Initialization Function (Below Min. Limit) h. Code 44 - TPS “Auto-Learn” Initialization Function (Above Max. Limit) i.
Code 51 - Injector 1 j. Code 52 - Injector 2 k. Code 55 - MIL (Diagnostic Light) l. Code 56 - Pump Relay Possible causes: 1. Battery 2. Main system fuse 3. MIL light bulb burned out 4. MIL electrical circuit problem. Pin circuits 29 and 84. 5. Ignition switch 6. Permanent ECU power circuit problem. Pin circuit 1. 7. Switched ECU power circuit problem. Pin circuit 2. 8 ECU grounds 9. ECU 5B Diagnostic Aid #2 “FAULT CODES” (Refer to detailed fault code listing before flow chart and “servicing” information for the respective components) 1. Code 21 - Engine Speed Synchronization 2. Code 22 - Throttle Position Sensor (TPS) 3. Code 23 - Engine Control Unit (ECU) 4. Code 31 - Oxygen Sensor 5.
Code 32 - Oxygen Sensor 6. Code 33 - Fuel System (temporary adaptation factor) 7. Code 34 - Fuel System (permanent adaptation factor) 8. Code 42 - Engine (Coolant) Temperature Sensor 9. Code 43 - TPS “Auto-Learn” Initialization Function. (Below Min. Limit) 10. Code 44 - TPS “Auto-Learn” Initialization Function. (Above Max. Limit) 11. Code 51 - Injector 1 12. Code 52 - Injector 2 13. Code 55 - MIL (Diagnostic Light) 14. Code 56 - Pump Relay 15. Code 61 - End of Fault/Blink Code Transmission. 2. MIL circuit grounded between light and ECU. Pin circuit 29. 3. ECU *NOTE: The MIL (diagnostic light) used must be a 1/4 watt incandescent lamp.
An LED style light will stay on continuously (dim) and should not be used. Diagnostic Aid #4 “SPEED SENSOR” (MIL does not turn off during cranking) Indicates the ECU is not receiving a signal from the speed sensor. Possible causes: 1. Speed sensor 2. Speed sensor circuit problem. Pin circuits 9 and 10. 3. Speed sensor/toothed wheel air gap 4. Toothed wheel 5. Flywheel key sheared 6. ECU 5B.35