Section 5B EFI Fuel System Diagnostic Aid #5 “FUEL PUMP” (fuel pump not turning on) Diagnostic Aid #10 “BASIC ENGINE” (cranks but will not run) Possible causes: 1. Fuel pump fuse 2. Fuel pump circuit problem. Circuits 30, 87, and relay. 3. Fuel pump Possible causes: 1. Refer to basic engine troubleshooting charts within service manual sections 3, 5, and 8. Common Complaints/Problems Following are some of the most common complaints or problems reported by customers. For each problem, you will find a list of the most likely causes or areas to be investigated. Always start by checking if there are any stored fault codes to guide you in the right direction.
Diagnostic Aid #6 “RELAY” (relay not operating) Possible causes: 1. Safety switches/circuit(s) problem. Circuit 25. 2. Relay circuit(s) problem. Circuits 28, 85, 30, and 87. 3. Relay 4. ECU grounds 5. ECU Engine starts hard or fails to start when cold. (Code 31, 42, 51, 52, 56) 1. Fuel pump or relay, not activating/operational. 2. Engine (Coolant) Temperature sensor faulty. 3. Fuel pressure insufficient/incorrect. 4. Fuel injector(s) leaking. 5. Fuel injector(s), fuel filter, fuel line, or fuel pick-up dirty, clogged, or restricted. 6. Speed sensor malfunction. 7. Stale fuel. 8. Low system voltage. 9. Bad spark plug(s) or coil(s). 10. Base ignition timing incorrect.
Diagnostic Aid #7 “IGNITION SYSTEM” (no spark) Possible causes: 1. Spark plug 2. Plug wire 3. Coil 4. Coil circuit(s). Circuits 30, 31, 65, 66, relay and relay circuit 30. 5. ECU grounds 6. ECU Diagnostic Aid #8 “FUEL SYSTEM-ELECTRICAL” (no fuel delivery) Engine starts hard or fails to start when warm. (Code 42, 51, 52) 1. Insufficient fuel system pressure. 2. Engine (Coolant) Temperature sensor faulty. 3. Fuel injector(s) leaking. 4. Fuel injector(s), fuel filter, fuel line, or fuel pick-up dirty/restricted. 5. Low fuel pressure. 6. Wrong grade of fuel. 7. Bad spark plug(s) or coil(s). 8. Low system voltage. 9. Speed sensor problem. 10. Base ignition timing problem. Possible causes: 1.
No fuel 2. Air in fuel rail 3. Fuel valve shut off 4. Fuel filter/line plugged 5. Injector circuit(s). Circuits 14, 15, 45 and 4A. 6. Injector 7. ECU grounds 8. ECU Diagnostic Aid #9 “FUEL SYSTEM” (fuel pressure) Possible causes for low fuel system pressure: 1. Low fuel 2. Fuel filter plugged 3. Fuel supply line plugged 4. Pressure regulator 5. Fuel pump Engine stalls or idles roughly. (Code 22, 31, 34, 42, 43, 51, 52) 1. Vacuum (intake air) leak. 2. Fuel injector(s), fuel filter, fuel line, or fuel pick-up dirty/clogged/restricted. 3. Insufficient fuel pressure/delivery. 4. Engine (Coolant) Temperature sensor faulty. 5. TPS faulty or “TPS Initialization Procedure” incorrect. 6.
Leaking fuel injector O-Rings. 7. Bad spark plug(s) or coil(s). Possible causes for high fuel system pressure: 1. Pressure regulator 2. Fuel return line plugged or restricted. 5B.36