Aegis LH630-775 — Section 6 - Lubrication System

Section 6 Lubrication System Section 6 Lubrication System General This engine uses a full pressure lubrication system. This system delivers oil under pressure to the crankshaft, camshaft and connecting rod bearing surfaces. In addition to lubricating the bearing surfaces, the lubrication system supplies oil to the hydraulic valve lifters. NOTE: Using other than service class SG, SH, SJ or higher oil, or extending oil change intervals longer than recommended can cause engine damage. NOTE: Synthetic oils meeting the listed classifications may be used with oil changes performed at the recommended intervals.

However, to allow piston rings to properly seat, a new or rebuilt engine should be operated for at least 50 hours using standard petroleum based oil before switching to synthetic oil. A high-efficiency gerotor pump is located in the closure plate. The oil pump maintains high oil flow and oil pressure, even at low speeds and high operating temperatures. A pressure relief valve in the closure plate limits the maximum pressure of the system. 6 Service The closure plate must be removed to service the oil pickup, the pressure relief valve, and the oil pump. Refer to the appropriate procedures in Sections 9 and 10.

A logo or symbol on oil containers identifies the API service class and SAE viscosity grade. See Figure 6-1. Oil Recommendations Using the proper type and weight of oil in the crankcase is extremely important; so is checking oil daily and changing the oil and filter regularly. Use high-quality detergent oil of API (American Petroleum Institute) service class SG, SH, SJ, or higher . Select the viscosity based on the air temperature at the time of operation as shown in the following table. Figure 6-1. Oil Container Logo. The top portion of the symbol shows service class such as API SERVICE CLASS SJ .

The symbol may 6.1 ** * *Use of synthetic oil having 5W-20 or 5W-30 rating is acceptable, up to 4°C (40°F). **Synthetic oils will provide better starting in extreme cold below -23°C (-10°F). show additional categories such as CC or CD. The center portion shows the viscosity grade such as SAE 10W-30. If the bottom portion shows ‘‘Energy Conserving,’’ it means that oil is intended to improve fuel economy in passenger car engines. Checking Oil Level The importance of checking and maintaining the proper oil level in the crankcase cannot be overemphasized. Check oil BEFORE EACH USE as follows: