Section 6 Lubrication System 1. Make sure the engine is stopped, level, and cool so the oil has had time to drain into the sump. Changing Oil and Oil Filter Change oil and oil filter after every 200 hours or annually, whichever comes first (more often under severe conditions). Refill with service class SG, SH, SJ or higher oil, as specified in the ‘‘Viscosity Grades’’ table on previous page. Always use a genuine Kohler oil filter. Use chart below to determine part number to order. 2. Clean the area around the dipstick before removing it. This will help to keep dirt, grass clippings, etc., out of the engine. 3. Pull out the dipstick and wipe off the oil.
Reinstall the dipstick into the tube and push it all the way in. See Figure 6-2. Change the oil while the engine is still warm. The oil will flow freely and carry away more impurities. Make sure the engine is level when filling or checking oil. Figure 6-2. Checking Oil Level. 4. Remove the dipstick and check the oil level. The level should be between the "F" and "L" marks. If low, add oil of the proper type to bring the level up to the "F" mark. Reinstall the oil fill cap and dipstick. Drain Plug "F" Mark Drain Plug Operating Range Figure 6-4. Oil Drain Plugs and Oil Filter. Change the oil and oil filter as follows (See Figure 6-4.): Figure 6-3. Oil Level Marks on Dipstick. 1.
To keep dirt, debris, etc. out of the engine, clean the area around the oil fill cap and the dipstick before removal. NOTE: To prevent extensive engine wear or damage, always maintain the proper oil level in the crankcase. Never operate the engine with the oil level below the "L" mark or above the "F" mark on the dipstick. 2. Remove one of the oil drain plugs and the dipstick. Be sure to allow ample time for complete drainage. 6.2 Oil Filter Part No. Length 12 050 01-S 2-1/2" 52 050 02-S 3-3/8"