Section 6 Lubrication System 3. Before removing the oil filter, clean the surrounding area to keep dirt and debris out of the engine. Remove the old filter and wipe/clean the surface where the filter mounts. Oil Sentry Some engines are equipped with an optional Oil Sentry oil pressure monitor. If the oil pressure decreases below an acceptable level, the Oil Sentry 4. Reinstall the drain plug. Make sure it is tightened to 13.6 N·m (10 ft. lb.) . will either shut off the engine or activate a warning signal, depending on the application. 5. Place a new oil filter in a shallow pan with the open end up. Pour new oil, of the proper type, in through the threaded center hole.
Stop pouring when the oil reaches the bottom of the threads. Allow a minute or two for the oil to be absorbed by the filter material. Operation The pressure switch is designed to break contact as the oil pressure increases, and make contact as the oil pressure decreases. At oil pressure above approximately 3.0/5.0 psi, the switch contacts open. Below this pressure, the switch contacts close. 6. Apply a thin film of oil to the rubber gasket on the new filter. On stationary or unattended applications (pumps, generators, etc.), the pressure switch can be used to ground the ignition module to stop the engine.
On vehicular applications (lawn tractors, mowers, etc.) the pressure switch can only be used to activate a warning light or signal. 7. Install the new oil filter to the filter adapter. Turn the oil filter clockwise until the rubber gasket contacts the surface, then tighten the filter an additional 3/4-1 turn. 6 NOTE: Make sure the oil level is checked BEFORE EACH USE and is maintained up to the ‘‘F’’ mark on the dipstick. This includes engines equipped with Oil Sentry . 8. Remove the oil fill cap from the valve cover. Fill the crankcase with new oil, of the proper type, to the "F" mark on the dipstick. Refer to "Oil Type" and "Check Oil Level" on pages 6.1 and 6.2.
Always check the level with the dipstick before adding more oil. Push dipstick in completely. Installation The Oil Sentry pressure switch is installed in the breather cover. See Figure 6-5. 9. Reinstall the oil fill cap and tighten securely by turning to the right. Oil Sentry Switch NOTE: To prevent extensive engine wear or damage, always maintain the proper oil level in the crankcase. Never operate the engine with the oil level below the ‘‘L’’ mark or above the ‘‘F’’ mark on the dipstick. Angle of Operation This engine will operate continuously at angles up to 20°. Check oil level to assure crankcase oil level is at the ‘‘F’’ mark on the dipstick.
Refer to the operating instructions of the equipment this engine powers. Because of equipment design or application, there may be more stringent restrictions regarding the angle of operation. Figure 6-5. Oil Sentry Location. On engines not equipped with Oil Sentry the installation hole is sealed with a 1/8-27 N.P.T.F. pipe plug. NOTE: Do not operate this engine continuously at angles exceeding 20° in any direction. Engine damage could result from insufficient lubrication. 6.3