Aegis LH630-775 — Section 6 - Lubrication System

Section 6 Lubrication System To install the switch, follow these steps: Breather Design and Function The breather system on these engines is designed to control and maintain the vacuum in the engine crankcase. When the pistons move downward, a controlled amount of crankcase air is pushed past the reed, which in turn closes when the pistons travel upward. The hole for the breather (reed) is positioned high in the crankcase, so that most of the oil mist has already been purged from the air before it enters the breather chamber. Remaining oil is separated through a baffle and filter, as the air moves through the chamber.

A hose connects the breather outlet to an adapter on top of the carburetor, where the vented breather air is mixed proportionately with the incoming combustion air on its way to the combustion chamber. A drain hole at the bottom of the chamber returns the separated oil to the crankcase. 1. Apply pipe sealant with Teflon ® (Loctite ® No. 59241 or equivalent) to the threads of the switch. 2. Install the switch into the tapped hole in the breather cover. See Figure 6-5. 3. Torque the switch to 4.5 N·m (40 in. lb.) . Testing Compressed air, a pressure regulator, pressure gauge and a continuity tester are required to test the switch. 1.

Connect the continuity tester to the blade terminal and the metal case of the switch. With 0 psi pressure applied to the switch, the tester should indicate continuity (switch closed) . 2. Gradually increase the pressure to the switch. As pressure increases through the range of 3.0/5.0 psi, the tester should indicate a change to no continuity (switch open) . The switch should remain open as the pressure is increased to 90 psi maximum . 3. Gradually decrease the pressure through the range of 3.0/5.0 psi . The tester should indicate a change to continuity (switch closed) down to 0 psi . 4. Replace the switch if it does not operate as specified. Figure 6-6. Reed/Breather Assembly in Crankcase.

Crankcase Breather System The crankcase breather system is a necessary complement to the lubrication system. To help prevent the engine oil from weeping out past shafts, seals, and gaskets during operation, it is desirable to have a low vacuum inside the crankcase. A typical crankcase breather system incorporates a simple one- way valve to provide the desired vacuum. Figure 6-7. Breather Cover. 6.4