Aegis LH630-775 — Section 7 - Cooling System

Section 7 Cooling System WARNING: Explosive release of fluids from pressurized cooling system can cause serious burns! When it is necessary to open cooling system at radiator cap, shut off engine and remove filler cap only when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. This section covers the operation and servicing of the liquid cooling system. Operation The engine coolant is pumped through the cooling system by a pump, belt-driven off the camshaft. The coolant coming out of the pump is divided, and moves simultaneously through separate circuits within each head and the corresponding sides of the crankcase.

As the coolant moves through these passages, it absorbs heat from the engine parts. After traveling through the engine, the coolant from the two separate circuits merges and moves through the intake manifold to the lower side of the thermostat. During warm-up, the thermostat is closed, preventing circulation through the radiator. The coolant circulates through the engine only and is returned to the pump via the bypass hose. When engine heat brings the coolant up to a temperature of 79.4°C (175°F), the thermostat will begin to open, allowing coolant to circulate through the upper hose to the radiator.

The thermostat is completely open at 90.5°C (195°F) allowing full coolant flow through the radiator, where it is cooled. After getting "cooled" in the radiator, the coolant is drawn into the pump through the lower radiator hose and circulation starts all over again. A cooling fan, driven off the flywheel by a belt, draws ambient air through the radiator, to maintain the cooling process. Cooling System Components The cooling system consists of the following components:

Radiator with removable screen Hoses Coolant Pump and Belt Thermostat Intake Manifold with Thermostat Housing Radiator Cap Cooling Fan, Belt, and Drive Pulleys Overflow Reservoir Crankcase and Heads with Integral Cooling Passages 7 Coolant Recommendations Use equal parts of ethylene glycol (antifreeze) and water only. Distilled or deionized water is recommended, especially in areas where the water contains a high mineral content. Propylene glycol based antifreeze is not recommended. Figure 7-1. Cooling System Components (Air Cleaner Removed For Clarity). This mixture will provide protection from -37°C (-34°F) to 108°C (226°F).

For protection and use outside the indicated temperature limits, follow the antifreeze manufacturer's instructions on the container, but do not exceed 70% antifreeze. 7.1 Section 7 Cooling System