Aegis LH630-775 — Section 7 - Cooling System

Section 7 Cooling System DO NOT use antifreeze with stop-leak additive(s), or put any other additives in the cooling system. Cooling System Maintenance and Service Maintenance Maintaining the correct coolant level, cleaning any debris accumulation from the radiator surfaces, and insuring all parts are in proper operating condition, is critical to ensuring long life, proper system performance and preventing overheating. To ensure proper air circulation, make sure the radiator, cooling fan, drive belt, pulleys, cooling fins, and external surfaces of the engine are kept clean and in good condition at all times .

Check the coolant level and clean away any debris accumulation daily or before each use. At the same time inspect the hoses and all system connections for signs of leakage. Make sure the cooling fan is not cracked or missing any blades. Check that the fan belt and the two drive pulleys, are in good condition and the proper belt tension is present. See Figure 7-2. Figure 7-3. Cleaning Radiator and Screen. Engine coolant should be changed every two years or 1000 hours, whichever comes first . When changing the engine coolant, the system should also be flushed to remove any contaminants left behind during draining.

Following are general recommended procedures for checking, draining, flushing, and filling the cooling system. Checking Coolant Level The coolant level should be checked at the overflow reservoir, located behind the radiator on the fan shroud. See Figure 7-4. Figure 7-2. Checking Belt Tension. Servicing Every 100 hours of operation (more often under extremely dusty, dirty conditions), clean the removable screen, cooling fins of the radiator, all shrouding and external surfaces of the engine as necessary. Check the condition of fan assembly and v- belt tension. Do not operate the engine without all shrouds and protective guards installed. Figure 7-4. Overflow Reservoir Location. 1.

Check the coolant level within the overflow reservoir. Coolant level should be between the "FULL" and "ADD" marks on the reservoir. See Figure 7-5. Do not operate the engine with the coolant level below the "ADD" mark. Lift the screen vertically to remove for cleaning/ servicing. Clean the screen and cooling fins of the radiator with a soft brush or blow out using clean compressed air. See Figure 7-3. To avoid damage to the screen and cooling fins, do not use a high pressure washer to clean. Add coolant to the overflow reservoir as required, which is a 50/50 mixture of ethylene glycol and water (distilled or deionized water is recommended). 7.2