Section 7 Cooling System Drain the coolant into a suitable container. Then remove the coolant drain plugs if equipped from the sides of the block and allow the remaining coolant to drain. See Figure 7-7. Figure 7-5. Coolant Levels on Reservoir. NOTE: Do not operate the engine without coolant in the system. Do not remove the radiator cap when hot. Engine coolant is hot and under pressure and can cause severe burns. To prevent engine overheating and damage, do not exceed more than 70% antifreeze in the cooling system. Coolant Drain Plug Figure 7-7. Engine Block Coolant Drain Plug (Some Models).
On the starter side it may be preferable to first remove the starter, or use a piece of cardboard formed in a "V" to drain the coolant out over the starter. After the coolant has drained, apply pipe sealant with Teflon ® (Loctite ® 59241 or equivalent) to the threads of the plugs and reinstall the plugs. Torque the plugs to 13.5 N·m (120 in. lb.) . Always use brass plugs when service is performed. Draining Cooling System 1. Stop the engine and let the engine cool sufficiently. 7 2. Slowly remove the radiator cap. 3. Loosen/remove the radiator drain plug in the lower left rear corner or the bottom of the radiator. See Figure 7-6. 4.
Unhook inboard catch and remove the overflow reservoir from its mounting location. See Figure 7-8. Remove the cap and pour out the contents of the reservoir. Wash or clean as required. Dispose of all the old coolant properly, according to local regulations. Radiator Drain Plug Radiator Drain Plug Figure 7-6. Radiator Drain Plug. Figure 7-8. Removing Reservoir. 7.3