Aegis LH630-775 — Section 7 - Cooling System

Section 7 Cooling System 5. Reinstall the reservoir into the mounting bracket, and install the cap. Do not kink/pinch the hose. 3. Fill the cooling system through the radiator neck. Allow coolant to drain into the lower areas. Fill the overflow reservoir midway between the ‘‘ADD’’ and ‘‘FULL’’ marks, then install the radiator and reservoir caps. 6. Flush the cooling system. Flushing Cooling System NOTE: To prevent engine damage, do not pour water into a hot engine. Do not operate engine without coolant. 4. Start engine, run for five minutes and let cool. 5. Check coolant level in reservoir. Coolant level should be between the "FULL’’ and ‘‘ADD’’ marks. See Figure 7-5.

Add coolant if required. With system properly drained: Inspection 1. Fill the cooling system with clean water and a cooling system cleaner recommended for aluminum engines. Follow the directions on the container. Cooling Fan Assembly, Belt, and Drive Pulleys The cooling fan assembly, used to draw the air through the radiator, is attached to a hub and pulley assembly with sealed ball bearings. This assembly is belt driven off the flywheel, via a lower split pulley, and requires very little service or maintenance. DO NOT operate the engine without the fan and properly functioning cooling system or engine damage will occur. See Figure 7-9. 2. Reinstall and tighten the radiator cap. 3.

Start and run the engine five minutes, or until it reaches operating temperature. 4. Drain the cooling system immediately, before contaminants settle (refer to "Draining Cooling System"). 5. Fill the cooling system. Filling Cooling System NOTE: To prevent engine damage, do not use antifreeze mixture greater than 70% ethylene glycol in the cooling system. Do not use antifreeze with stop-leak additive(s) or mix/ add other additives to the cooling system. Use only ethylene glycol antifreeze. Cooling system capacity is approximately 2 liters (2.18 qt.) Figure 7-9. Cooling System (Front View). 1. Inspect the fan for any cracks, damaged/missing fan blades, and secure mounting. 1.

Check the condition of cooling system hoses, clamps, and associated components. Replace as required. 2. The bearings in the hub of the pulley should rotate smoothly, without roughness, binding, or play/wobble. 2. Mix 50% ethylene glycol with 50% distilled or deionized water (See Coolant Recommendation). For extremely cold temperature applications or protection outside the limits listed in the Coolant Recommendation Section, refer to the antifreeze manufacturer's instructions on the container. 3. The v-groove of each pulley (upper and lower) should not be bent, nicked, or damaged. Pulley mounting areas and lower pulley shims should be free of any cracks or elongation. 7.4