Aegis LH630-775 — Section 7 - Cooling System

Section 7 Cooling System 4. The drive belt is designed and constructed for this system. Do not use a substitute belt. Check the overall condition and replace the belt if cracked, damaged, or proper tension cannot be established by repositioning of the lower pulley shims. Use only Kohler Part No. 66 203 02-S belt if replacement is necessary. See an authorized Kohler Service Dealer for any necessary service. Checking Fan Belt and Tension The fan belt and belt tension should be checked daily or before each use. The fan belt should not be cracked, damaged, or exhibit excessive wear. Proper tension is 3/8" - 1/2" (12.7 mm) belt deflection per side under 10 lbs . applied tension. See Figure 7-10.

Figure 7-11. Torquing Lower Pulley Mounting Screws. Hoses and Tubes Hoses and tubes are used to connect the components within the cooling system. To guard against coolant loss and hose failure, the hoses, tubes and their connections should be checked regularly for leaks or damage. Loss of coolant can result in serious engine damage. Over time, engine vibration can affect hose/ joint connections, and the hoses themselves can be affected by heat and the coolant. Swelling, hardening, and/or deterioration can occur depending on the operating environment. Deterioration usually takes place more rapidly from the inside, making outside inspections incomplete and not always dependable.

Regular outside inspection and careful inside inspection whenever connections are opened, can minimize a possible ‘‘in-service’’ problem. 7 Figure 7-10. Checking Belt Tension. If the belt is cracked, damaged, or is worn to the extent that relocation of pulley shims cannot establish proper belt tension, the belt should be replaced. Use only Kohler Part No. 66 203 02-S belt. DO NOT use a substitute belt. Use new clamps whenever a hose is replaced or a joint connection is opened. When making hose connections, a light coating of rubber lubricant will make assembly easier. For a new belt, assemble the lower pulley with all three shims between the pulley halves.

For a used/ original belt being reinstalled, assemble with two or one shim(s) between the pulley halves and remaining shim(s) on the outside (front) of the outer pulley half. Check the belt tension as described above. Thermostat Testing and Servicing The thermostat is mounted in the intake manifold, beneath the thermostat housing. See Figure 7-12. It controls the rapid warm-up and operating temperature of the engine. If a problem is encountered which is thought to be the fault of the thermostat, it can be checked to determine its operating condition.

Before removing and testing the thermostat, make sure all other possible causes such as debris accumulation/obstruction, leaks, belt or fan failure, coolant level, and damaged components are eliminated as possible causes. When proper tension is obtained, individually remove, each capscrew of the lower pulley apply Loctite ® No. 242 to the threads and reinstall. Torque each of the four capscrews in a criss-cross sequence to 24.5 N·m (215 in. lb.) . See Figure 7-11. 7.5