Section 7 Cooling System 5. Reconnect the radiator hose and secure with the hose clamp, if separated previously. Intake Manifold High Temperature Sensor A high temperature sensor may be mounted in the intake manifold and is used to activate a warning light, audible alarm, or kill the engine (depending on the application), if the safe operating temperature is exceeded. The sensor is a ‘‘normally open’’ switch which completes a circuit, when the coolant temperature reaches the rated temperature limit of the switch. For these engines the temperature sensor limit is 123.8°C (255°F). Thermostat Figure 7-12. Intake/Thermostat. To Test Remove the thermostat from the system.
Hang or suspend the thermostat by its frame in a container of water, so the thermostat does not touch the bottom of the container. Heat the water and measure the temperature (an oven thermometer can be used). The spring-loaded valve of the thermostat should begin to open at 79.4°C (175°F), and can be completely open at 90°C (195°F). If the valve opens at a temperature more than 10 degrees below the specified opening or fails to open at a temperature 10 to 15 degrees above the specified opening, the thermostat should be replaced.
If the valve in the thermostat can be moved or pushed off its seat with a slight effort when the thermostat is cold, the unit may be considered defective and should be replaced. The thermostat should be replaced if operation is found to be questionable or faulty. Temperature Sensor Installation 1. Thoroughly clean the sealing surfaces of the intake manifold and thermostat housing with an aerosol gasket remover. Make sure the sealing surfaces are clean and free of nicks or damage. Make sure the notch in the intake manifold is clean. Audible Alarm Figure 7-13. Warning Devices.
If the warning device activates, or the engine kills, indicating an excessive operating temperature, check the following: 2. Install a new thermostat into the intake manifold, so the larger spring end is down into the well of the intake manifold. Position a new thermostat gasket on the intake manifold. 1. Make sure fan belt is in good condition and properly tensioned. 3. Install the thermostat housing onto the intake manifold. 2. Make sure cooling fan is properly secured, not broken, damaged, or missing blades. 4. Install and torque the two hex flange screws to 9.9 N·m (88 in. lb.) . 3. Make sure all air intake and cooling surfaces are clean and free of debris accumulation. 7.6