Aegis LH630-775 — Section 7 - Cooling System

Section 7 Cooling System 4. After the engine has sufficiently cooled, check the coolant level in the system to make sure it is not low, or improperly mixed. Test Instructions 1. With the engine cool, carefully remove the radiator cap (see Pressure Radiator Cap Section). Make sure all parts of the cap and adapter are clean. Install the cap on the corresponding adapter and make sure it is completely seated. Install the adapter onto the tester and lock in place. See Figure 7-15. 5. Check cooling system for leaks. 6. Check the thermostat, and pressure test the radiator cap. 7. Make sure the water pump and the drive belt are operational. 8.

Check and inspect the wiring from the sensor for shorting or damage. If none of those are found to be the cause do the following: 1. Drain coolant from the system, so the level is lower than the installed position of the temperature sensor. 2. Remove and replace the temperature sensor. Use pipe sealant with Teflon ® on the threads. Figure 7-15. Adapter Installed onto the Tester. 7 Cooling System Leakage Test A pressure test of the cooling system can be performed as a relatively simple means of determining whether the cooling system may contain a leak. A pump/pressure type cooling system tester with the appropriate 45 mm adapter may be used to check the cooling system and the radiator cap.

A typical tester and adapter is shown in Figure 7-14. 2. Pressurize the tester to 15 psi. 3. Observe the indicated pressure. It should hold steady and not decrease or leak down. If leakage is detected, the cap should be replaced. If the tester pressure is increased to 16 psi, or above, the cap should then ‘‘bleed off’’ this excess pressure. 4. Install and lock the system adapter and tester onto the neck of the cooling system. Pressurize the tester to 14-15 psi. See Figure 7-16. Figure 7-14. A Typical Tester and Adapter. Figure 7-16. Adapter and Tester Installed. 7.7