Section 7 Cooling System 5. Observe the system pressure on the gauge. If a pressure loss is noted: 1. With pressure on the system, apply a soap/water solution and check all joint connections, hoses, and cooling system components for external leakage. Repair or replace as required. Gauge Needle Holds Steady If the gauge needle holds steady, there should be no serious leaks in the system. It is however, recommended that all connections be checked for overall condition anyway, using a flashlight. 2. Remove the dipstick and check the appearance of the oil in the crankcase. Another method would be to remove an oil drain plug and drain a small amount of oil for inspection.
A milky or an opaque color, similar to chocolate milk, indicates the presence of engine coolant in the oil. Check for a blown head gasket (step 3 below) or a possible crack or internal leakage from the water jacket. Gauge Needle Drops Slowly If the gauge needle drops slowly it indicates the presence of a small leak or seepage. Check all components and connections for signs of leakage. Check the condition of the radiator hoses. If they swell excessively while testing the system, they may be weak and should be replaced. 3. Remove the spark plugs. Apply 14-15 lbs. of pressure and listen/inspect for internal coolant leakage into the cylinder/combustion chambers.
This can denote a head gasket failure/leak. If required, further test by performing a ‘‘Cylinder Leakdown Test’’ as described in Section 3. Gauge Needle Drops Quickly A steady drop or loss of pressure indicates serious leakage is occurring within the system, which must be located and corrected before the engine is returned to service. 7.8