Section 8 Electrical System and Components This section covers the operation, service, and repair of the electrical system components. Systems and components covered in this section are: 2. Remove the plug and check its condition. See “Inspection” following this procedure. Replace the plug if necessary. Spark Plugs Battery and Charging System Electronic CD Ignition System Electric Starter NOTE: Do not clean spark plug in a machine using abrasive grit. Some grit could remain in the spark plug and enter the engine causing extensive wear and damage. Spark Plugs Engine misfire or starting problems are often caused by a spark plug that has improper gap or is in poor condition. 3.
Check the gap using a wire feeler gauge. Adjust the gap to 0.76 mm (0.030 in.) by carefully bending the ground electrode. See Figure 8-1. The engine is equipped with the following spark plugs: Type: The standard spark plug is a Champion ® RC14YC (Kohler Part No. 66 132 01-S). Equivalent alternate brand plugs can also be used. Gap: 0.76 mm (0.030 in.) Thread Size: 14 mm Reach: 19.1 mm (3/4 in.) Hex Size: 16 mm (5/8 in.) Spark Plug Service Annually or every 200 hours of operation (whichever comes first), remove the spark plugs, check condition, and reset the gap or replace with new spark plugs as necessary. Every 500 hours of operation, replace the spark plugs.
To service the spark plugs perform the following steps: Figure 8-1. Servicing Spark Plug. 1. Before removing each spark plug, clean the area around the base of the plug to keep dirt and debris out of the engine. 4. Reinstall the spark plug into the cylinder head and tighten to 24.4-29.8 N·m (18-22 ft. lb.) . 8.1 Section 8 Electrical System and Components Wire Gauge Spark Plug Ground 0.76 mm Electrode (0.030 in.) Gap 8