Section 8 Electrical System and Components WARNING: Explosive Gas! Batteries produce explosive hydrogen gas while being charged. To prevent a fire or explosion, charge batteries only in well ventilated areas. Keep sources of ignition away from the battery at all times. Keep batteries out of the reach of children. Remove all jewelry when servicing batteries. Before disconnecting the negative (-) ground cable, make sure all switches are OFF. If ON, a spark will occur at the ground cable terminal which could cause an explosion if hydrogen gas or gasoline vapors are present. 1. Regularly check the level of electrolyte. Add distilled water as necessary to maintain the recommended level.
Overheated: Chalky, white deposits indicate very high combustion temperatures. This condition is usually accompanied by excessive gap erosion. Lean carburetor settings, an intake air leak, or incorrect spark timing are normal causes for high combustion temperatures. NOTE: Do not overfill the battery. Poor performance or early failure due to loss of electrolyte will result. Battery 2. Keep the cables, terminals, and external surfaces of the battery clean. A build-up of corrosive acid or grime on the external surfaces can cause the battery to self-discharge. Self-discharge occurs rapidly when moisture is present.
General A 12-volt battery with 400 cold cranking amps is generally recommended for starting in all conditions. A smaller capacity battery is often sufficient if an application is started only in warmer temperatures. Refer to the following table for minimum capacities (cca) based on anticipated ambient temperatures. The actual cold cranking requirement depends on engine size, application, and starting temperatures. The cranking requirements increase as temperatures decrease and battery capacity shrinks. Refer also to the operating instructions of the equipment being this engine powers for specific battery requirements. 3.
Wash the cables, terminals, and external surfaces with a mild baking soda and water solution. Rinse thoroughly with clear water. 8 NOTE: Do not allow the baking soda solution to enter the cells as this will destroy the electrolyte. Battery Size Recommendations Battery Test To test the battery, you will need a DC voltmeter. Perform the following steps. See Figure 8-2: 1. Connect the voltmeter across the battery terminals. 2. Crank the engine. If the battery drops below 9 volts while cranking, the battery is too small, discharged, or faulty. If the battery charge is not sufficient to turn over the engine, recharge the battery.
Battery Maintenance Regular maintenance is necessary to prolong battery life. 8.3 Temperature Battery Required Above 32°F (0°C) 200 cca minimum 0°F to 32°F (-18°C to 0°C) 250 cca minimum -5°F to 0°F (-21°C to -18°C) 300 cca minimum -10°F (-23°C) or below 400 cca minimum