Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Suspension 32 to lubricate until grease exits both ends of the bushing. If the pin will not accept lubricant, re- move the pin and clean the lubrication channels where lubricant may have hardened. Remove the safety stands and lower the vehicle after lubrica- tion is complete. Hendrickson Walking Beam, Series RS No lubrication is required on RS Series suspensions equipped with rubber bushings. If the equalizer beam has a bronze center bushing, apply multipurpose grease at the beam grease fitting on the equalizer beam center hub, until clean grease appears at both ends of the grease seals. Chalmers Walking Beam 4 2 3 No lubrication is required on the Chalmers rear sus- pension.

32–03 Suspension U-Bolt Torque Checking 2 CAUTION 4 1 Failure to retorque the U-bolt nuts could result in spring breakage and abnormal tire wear. 09/15/95 f320424 1. Bronze Bushing 2. Lubrication Hole 3. Grease Fitting 4. Lubrication Groove 1. Park the vehicle on a flat surface and apply the parking brakes. Chock the tires to prevent the vehicle from moving. Fig. 22, Hendrickson RT2 and RTE2 Series Bushing Lubrication 2. Check the U-bolt torque in a diagonal pattern. Set a click-type torque wrench to the highest torque value for the fastener being checked. See Table 1 for U-bolt torque specifications. Turn the wrench in a clockwise motion (looking up) until the torque wrench clicks.

Neway No lubrication is required on Neway rear suspen- sions. Reyco 3. Remove the chocks. No lubrication is required on Reyco rear suspen- sions. Heavy-Duty Trucks Maintenance Manual, October 2009 32/12