Front Axle 33 33–01 Knuckle Pin Lubricating plate gasket, continue pumping until new grease is seen at the bushing seal opposite the grease fitting. See Fig. 2 . CAUTION Use regulated pressure when lubricating the knuckle assemblies, otherwise damage could re- sult to the knuckle caps. Dana Spicer 1 Park the vehicle on a level surface, apply the parking brakes, and chock the tires. When lubricating upper and lower knuckle assemblies, do not raise the front axle.
Wipe the fittings clean, then apply multipurpose chassis grease, NLGI grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI grade 2 (8% 12- hydroxy lithium stearate grease), until new grease is seen at the junctions of the axle beam and knuckles. See Fig. 1 . Knuckle pins without grease fittings are permanently lubricated. A 09/06/96 f320032a 1 1 A. Grease Exit 1. Grease Fitting Fig. 2, Meritor Knuckle Pin Lubrication Freightliner When lubricating upper and lower knuckle assem- blies, do not raise the front axle.
Wipe the lube fit- tings clean, and apply multipurpose chassis grease, NLGI grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI grade 2 (8% 12-hydroxy lithium stearate grease) until new grease is seen at the junc- tions of the axle beam and knuckles. See Fig. 3 . 11/21/95 f330129 33–02 Tie Rod Inspecting and Lubricating A. Grease Exit 1. Grease Fitting Fig. 1, Dana Spicer Knuckle Pin Lubrication Meritor Inspect the tie-rod ends as follows: When lubricating knuckle pin bushings, do not raise the front axle.
Wipe the lube fittings clean, and apply multipurpose chassis grease, NLGI grade 1 (6% 12- hydroxy lithium stearate grease) or NLGI grade 2 (8% 12-hydroxy lithium stearate grease) until new grease is seen at the bushing grease seal opposite the fittings. The grease seal will accept grease pres- sure without damage, and is designed to have grease pumped out through it during lubrication. Even if grease leaks out around the top, or bottom- 1. Shake the cross-tube. A loose fit, or movement between the tapered shaft of the ball and the cross-tube socket members indicates that the tie-rod end assembly must be replaced. 2.
The threaded portion of the tie-rod end assembly must be inserted all the way into the cross-tube split for adequate clamping. See Fig. 4 . Replace the components if this cannot be done. For in- structions, see Group 33 of the Heavy-Duty Trucks Service Manual. Heavy-Duty Trucks Maintenance Manual, June 2001 33/1 A 1