Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Front Axle 33 1 12-hydroxy lithium stearate grease), into the tie- rod ends until all used grease is forced out and fresh grease is seen at the ball stud neck. 33–03 All-Axle Alignment Checking A Drive Axle Alignment Checking 1 Check the axle alignment, parallelism, and thrust angle measurements for the rear drive axles. Use the applicable procedure and specifications in Group 35 of the Heavy-Duty Trucks Service Manual. Toe-In Inspection f320360a 05/31/2005 Pump lubricant into each grease fitting until fresh grease come out at point A. For vehicle alignment to be accurate, the shop floor must be level in every direction.

The turn plates for the front wheels must rotate freely without friction, and the alignment equipment must be calibrated every three months by a qualified technician from the equipment manufacturer. Freightliner dealers must have proof of this calibration history. 1. Grease Fitting Fig. 3, Freightliner Knuckle Pin Lubrication OK 1. Apply the parking brakes and chock the rear tires. 2. Raise the front of the vehicle until the tires clear the ground. Check that the safety stands will support the combined weight of the cab, axle, and frame. Place safety stands under the axle. 1 3. Using spray paint or a piece of chalk, mark the entire center rib of each front tire. OK 4.

Place a scribe or pointed instrument against the marked center rib of each tire, and turn the tires. The scribe must be held firmly in place so that a single straight line is scribed all the way around each front tire. 5. Place a turn-plate or turntable under both front tires. Raise the front of the vehicle, remove the safety stands from under the axle, then lower the vehicle. Remove the lock-pins from the gauges; make sure the tires are exactly straight ahead. NOTE: If turn-plates or turntables are not avail- able, lower the vehicle. Remove the chocks from the rear tires and release the parking brakes. Move the vehicle backward and then forward about six feet (two meters). 02/27/2007 NOTE:

Pinch bolt not shown to provide clarity. f320033a 1. Cross-Tube Split Fig. 4, Tie-Rod End Adjustment 3. For any Dana Spicer, Meritor, or Freightliner axle that requires lubrication of the tie-rod ends, wipe the grease fittings clean, then pump multipurpose chassis grease, NLGI grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI grade 2 (8% Heavy-Duty Trucks Maintenance Manual, June 2001 33/2