Rear Axle 35 35–01 Axle Breather and Lubricant Level Checking 4. Lubricant should be level with the bottom of the fill hole ( Fig. 2 ) or with the top of the standpipe opening. If low, check the axle for oil leaks, and correct as needed. Add lubricant as required. See Table 1 for recommended drive axle lubricants. Eaton Axle Lubricant Level Checking CAUTION A Failure to keep the rear axle filled to the proper level with the recommended lubricant can result in rear axle damage. 1. With the vehicle parked on level ground, apply the parking brakes, and chock the tires. B 2. If the vehicle has just been driven, allow a few minutes for the lubricant to settle. 08/17/2009 A.
Correct (lube level at bottom of fill hole) B. Incorrect (lube level below fill hole) f350061a 3. Clean the oil fill plug and area surrounding it, then remove the plug from the fill hole ( Fig. 1 ) or from the standpipe (if so equipped) installed in the fill hole. Fig. 2, Axle Lubricant Level Checking Lubricant Type Condition Lubricant SAE Viscosity Grade Eaton Drive Axle Recommended Lubricant 1 Eaton ® Roadranger ® Synthetic Drive Axle Lubricants, or Equivalent with Military Specification MIL–L–2105D Over-the-Road Service 75W–90 Off-Highway Equipment, or Under Extra Heavy Loads 80W–140 5. Install and tighten the fill plug 40 to 60 lbf·ft (54 to 81 N·m).
Table 1, Eaton Drive Axle Recommended Lubricant 2 3 6. On non-drive axles equipped with oil-lubricated wheel bearings, check the lubricant level at the wheels. If low, add the same lubricant specified for the drive axle. NOTE: When adding or checking lubricant of non-drive axles, clean the hub cap and plug be- fore removing the plug. This minimizes the pos- sibility of dirt entering the assembly 06/07/94 f350002a 1. Axle Housing Breather 2. Fill Plug 3. Temperature Indicator Plug Fig. 1, Axle Housing IMPORTANT: A lubricant level close enough to be seen or touched is not sufficient. It must be level with the bottom of the fill hole ( Fig. 2 ) or top of the standpipe opening. 7.
Remove the chocks from the tires. Heavy-Duty Trucks Maintenance Manual, January 1997 35/1