Rear Axle 35 Eaton Two-Speed-Axle Shift Unit Oil Level API service classification SD (sulfated ash con- tent must not exceed 1.85%). This cold-weather mixture can be safely used up to 32°F (0°C). CAUTION Commercially available automatic transmission fluid may be used in place of SAE 10 engine oil. Automatic transmission fluid can be used for all temperatures; do not mix kerosene with it. Failure to keep lubricant at the specified level could cause damage to the axle shift unit. 3. Apply a small amount of Loctite ® 242, or equiva- lent sealant, to the threads of the fill plug. Install the fill plug finger-tight; then, using a wrench, tighten it 1-1/2 turns past finger-tight.
Eaton Axle Breather Checking 1. Clean the shift unit oil fill plug, and area sur- rounding it. See Fig. 3 . Remove the fill plug. Axle housing breathers ( Fig. 1 ) must remain un- clogged. Whenever the axle lubricant level is checked, be sure the axle breather is open. Check more often under adverse operating conditions. If the breather is plugged or damaged, clean or replace it as needed. Meritor Axle Lubricant Level Checking 1 2 3 CAUTION f350021a 08/06/93 1. Housing Cover Gasket 2. Oil Fill Plug 3. Shift Unit Housing Cover Failure to keep the rear axle filled to the proper level with the recommended lubricant can result in rear axle damage. 2.
The lubricant level should be maintained at the bottom of the fill hole. If low, add specified lubri- cant. Fig. 3, Two-Speed-Axle Shift Unit 1. With the vehicle parked on level ground, apply the parking brakes, and chock the tires. 2. Clean the fill plug in the side of the axle carrier, and the area surrounding it. See Fig. 4 . Then remove the plug. NOTE: Some Meritor axles have a small tapped and plugged hole near and below the housing oil fill hole. This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. CAUTION Before adding additional lubricant, make sure of the type currently in the shift unit.
To prevent component damage, do not mix engine oil with automatic transmission fluid. IMPORTANT: When vehicle operating tempera- tures are above 0°F (–18°C), use SAE 10 heavy-duty engine oil, API service classification SD (sulfated ash content must not exceed 1.85%). When vehicle operating temperatures are below 0°F (–18°C), use one part kerosene to three parts SAE 10 heavy-duty engine oil, 3. With the vehicle on level ground, lubricant should be level with the bottom of the fill hole. If low, check for oil leaks, correct as needed, then add specified lubricant. See Table 2 for recom- mended drive axle lubricants. Heavy-Duty Trucks Maintenance Manual, January 1997 35/2