Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Rear Axle 35 Meritor Drive Axle Recommended Lubricant Recommended Lubricant Type Ambient Temperature Lubricant SAE Viscosity Grade Meritor Specification +10°F (–12.2°C) and up * 85W–140 Hypoid Gear Oil API Service Classification GL–5 (–26.1°C) and up * 80W–140 (–26.1°C) and up * 80W–90 (–40°C) and up * 75W–90 (–40°C) to +35°F (+2°C) 75W (–40°C) and up * 75W–140 Synthetic Gear Oil (–40°C) and up * 75W–90 (–40°C) and up * 75W–140 * There is no upper limit on these ambient temperatures, but axle sump temperature must never exceed 250°F (121°C). Table 2, Meritor Drive Axle Recommended Lubricant 4. Install and tighten the fill plug 35 lbf·ft (47 N·m). NOTE:

When adding to or checking the oil level of non-drive axles, make certain the hub cap and plug are cleaned before removal of the plug; this will minimize the possibility of dirt and road grime entering the assembly. Meritor Axle Breather Checking Axle housing breathers ( Fig. 4 ) must remain clean. Whenever the axle lubricant level is checked, check the axle breather to be sure it is open. Check more often under adverse operating conditions. If the breather is plugged, clean or replace it as needed. 5. On non-drive axles using oil-lubricated wheel bearings, check oil level at the wheels, and add oil if low. Use the same lubricant as specified for the drive axle.

35–02 Axle Lubricant Changing, Oil Filter Replacing, and Magnetic Strainer Cleaning 1 Eaton Axle Lubricant Changing and Magnetic Strainer Cleaner CAUTION Failure to change the axle lubricant at more fre- quent intervals, when adverse operating condi- tions require, could result in axle damage. Draining is best accomplished immediately after the vehicle has completed a trip. The lubricant is warm then and will run freely, allowing full drainage in mini- mum time. This is especially desirable in cold weather. 2 3 06/07/94 f350062a 1. Axle Housing Breathers 2. Carrier Oil Fill Plugs 3. Interaxle Differential 1.

With the vehicle parked on level ground, apply the parking brakes, and chock the tires. Fig. 4, Fill Plug and Axle Housing Breather Locations Heavy-Duty Trucks Maintenance Manual, January 1997 35/3