Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Rear Axle 35 2. Clean the fill plug and area surrounding it, then remove the plug from the oil fill hole (or stand- pipe if installed in the oil fill hole) located in the axle housing rear cover. See Fig. 5 . 3. Remove the drain plug at the bottom of the axle housing ( Fig. 5 ) and allow sufficient time for all old lubricant to run out. 4. On tandem drive axles, also remove the plug at the bottom of the power divider to drain oil from the power divider. 2 1 1 05/27/93 f350017a 1. Magnetic Strainer 2. Power Divider 2 Fig. 6, Eaton Tandem-Drive-Axle Magnetic Strainer 5.2 Wash the strainer in solvent, and blow it dry with compressed air to remove oil and metal particles.

5.3 Install and tighten the magnetic strainer 40 to 60 lbf·ft (54 to 81 N·m). f350018a 05/27/93 1. Oil Fill Plug 2. Drain Plug 6. Clean the fill and drain plugs. To facilitate clean- ing of magnetic plugs, a piece of key stock or any other convenient steel slug may be used to short the two magnetic poles and divert the mag- netic field. Fig. 5, Axle Housing Drain and Fill Plugs NOTE: Some tandem drive axles are equipped with a cylindrical magnetic strainer, below the lube pump on the front of the power divider cover, that must be removed and cleaned at each axle oil change. See Fig. 6 . IMPORTANT:

Magnets will rapidly lose effective- ness as collected material bridges the gap be- tween the two poles. Clean or change the plugs before this occurs. It may be necessary to clean or change the plugs one or more times between lubrication change intervals. 5. Remove and clean the magnetic strainer, if so equipped. 5.1 Remove the magnetic strainer from the power divider cover. 7. After cleaning, install and tighten the drain plug(s) 40 to 60 lbf·ft (54 to 81 N·m). WARNING 8. Fill the axle with the recommended lubricant. See Table 1 for recommended drive axle lubri- cants, and Table 3 or Table 4 for drive axle lubri- cant capacities.

Always wear eye protection when using com- pressed air to clean parts, as flying debris could cause permanent damage to unprotected eyes. Do not point the air stream in the direction of other persons. Heavy-Duty Trucks Maintenance Manual, January 1997 35/4