Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Rear Axle 35 Eaton Single Drive Axle Lubricant Capacities Axle Type Axle Model Capacity * : pints (liters) 23085S, 23085D 40 (18.9) Single Reduction 23105S, 23105D 48 (22.7) 23121 41 (19.4) 30105S 46 (21.8) 1 3 Double Reduction 35055P 36 (17.0) 2 * Quantities listed are approximate. Fill axle until lubricant is level with bot- tom of fill hole with vehicle on level ground. Table 3, Eaton Single Drive Axle Lubricant Capacities NOTE: Some Eaton axles have a small tapped and plugged hole near and below the housing oil fill hole. See Fig. 1 . This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. 05/27/93 f350019a 1. Fill Plug 2.

Power Divider 3. Forward Differential Carrier Fig. 7, Power Divider Fill Plug 8.1 Using recommended lubricant, fill the axle through the oil fill hole or standpipe open- ing. Lubricant should be level with the bottom of the oil fill hole ( Fig. 2 ) or top of the standpipe opening. 110 lbf·in (1020 to 1240 N·cm), then remove the oil fill plug from the cover. IMPORTANT: When vehicle operating tempera- tures are above 0°F (–18°C), use SAE 10 heavy-duty engine oil, API service classification SD (sulfated ash content must not exceed 1.85%).

When vehicle operating temperatures are below 0°F (–18°C), use one part kerosene to three parts SAE 10 heavy-duty engine oil, API service classification SD (sulfated ash con- tent must not exceed 1.85%). This cold-weather mixture can be safely used up to 32°F (0°C). 8.2 Install and tighten the fill plug 40 to 60 lbf·ft (54 to 81 N·m). 8.3 For forward drive axles, remove the power divider fill plug, located slightly off- set to the right in the top portion of the forward differential carrier. See Fig. 7 . Add two pints (1 L) of lubricant through this fill hole. Do not use the hole at the top of the differential carrier as a fill hole.

Install and tighten the fill plug 40 to 60 lbf·ft (54 to 81 N·m). Eaton Two-Speed Axle Shift Unit Oil Changing Commercially available automatic transmission fluid may be used in place of SAE 10 engine oil. Automatic transmission fluid can be used for all temperatures; do not mix kerosene with it. To prevent component damage, do not mix engine oil and automatic transmission fluid. 4. Fill the shift unit housing through the oil fill hole until specified lubricant is level with the bottom of the opening. 1. Remove the shift unit housing cover ( Fig. 3 ). Drain and discard the old lubricant. Discard the housing cover gasket. 5.

Apply a small amount of Loctite ® 242, or equiva- lent sealant, to the threads of the fill plug. Install the plug finger-tight; then, using a wrench, tighten it 1-1/2 turns past finger-tight. 2. Thoroughly wash the axle shift parts and housing cover, and allow them to air dry. 3. Install the housing cover and a new cover gas- ket. Tighten the housing cover capscrews 90 to Heavy-Duty Trucks Maintenance Manual, January 1997 35/5