Rear Axle 35 3.3 Remove the capscrews, washers, and oil filter adapter from the gear cover; then inspect the threads of the filter mounting tube and adapter casting. See Fig. 10 . If the threads are stripped or the casting is cracked, replace the damaged component. NOTE: Meritor recommends plugs with ele- ments having a minimum pickup capacity of 1-1/2 pounds (0.7 kg) of low-carbon steel, in plate or bar form. Magnets will rapidly lose ef- fectiveness as collected material bridges the gap between the two poles. Clean or change the plugs before this occurs. It may be neces- sary to clean or change the plugs one or more times between lubrication change intervals. 6.
After cleaning the drain plug(s), install and tighten it 35 lbf·ft (47 N·m). 7. With the vehicle on a level surface, fill the axle housings to the bottom of the fill hole, using specified lubricant. See Table 2 for recom- mended axle lubricants, and Table 5 or Table 6 for drive axle lubricant capacities. NOTE: Some Meritor axles have a small tapped and plugged hole near and below the housing lubricant fill hole. This smaller hole is for a lubri- cant temperature indicator only, and should not be used as a fill or level hole. Fig. 10, Axle Oil Filter Adapter Removal and Installation 05/27/93 f350118a 3.4 Place the oil filter adapter in its bore.
In- stall the washers and capscrews, then tighten the capscrews 20 to 30 lbf·ft (27 to 41 N·m). 8. Install and tighten the fill plug 35 lbf·ft (47 N·m). 9. Whenever the interaxle differential housing has been drained, add an additional 2 pints (1 L) of specified lubricant directly into the interaxle differ- ential housing. 3.5 Using the specified drive axle lubricant, coat the face of the gasket on a new oil filter. Install the filter over the adapter, tighten the filter one full turn after the gasket contacts the base; do not over- tighten the filter. 10.
Remove the chocks, then drive the vehicle, un- loaded, for 1 or 2 miles (2 or 3 km) at speeds not to exceed 25 mph (40 km/h), to thoroughly circulate lubricant throughout the carrier and housing assemblies. 3.6 Assemble the filter cover over the filter and shouldered studs, and secure it with two nuts and washers. Tighten the nuts 10 to 15 lbf·ft (14 to 20 N·m). Meritor Single Drive Axle Lubricant Capacities Axle Type Axle Model Capacity * : pints (liters) 4. For a new or reconditioned axle, flush the axle with clean flushing oil, then drain it thoroughly. It is necessary to flush the axle the first time (only) that the axle lubricant is changed.
RS–23–160 39.5 (18.7) RS–23–161 37.2 (17.6) Single Reduction RS–23–180 47.3 (22.4) IMPORTANT: Axles should not be flushed with any solvent, such as kerosene. RS–26–180 46.6 (22.0) RS–30–180 46.6 (22.0) 5. Clean the fill and drain plugs. For magnetic plugs, a piece of key stock or any other conve- nient steel slug may be used to short the two magnetic poles and divert the magnetic field. Heavy-Duty Trucks Maintenance Manual, January 1997 35/8