Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Rear Axle 35 er’s manual. Meritor’s experience shows that the fol- lowing additives (friction modifiers) perform ad- equately: IMPORTANT: When the drive unit is equipped with an oil filter, the filter should be replaced every time the oil is changed. A. For all GL–5 gear oils (mineral oil or synthetic) other than Mobil, add any of the following (1.6 ounces [35 mL] of additive for each pint [0.5 L] of lube capacity): 3.1 To remove the filter from the helical gear cover, remove only the two relief valve cover stud nuts and washers, then lift off the filter cover. Do not remove the cap- screws. See Fig. 8 . Elco No. 2 Friction Modifier (Elco Corpora- tion).

3.2 Remove the oil filter, using a suitable filter strap wrench. See Fig. 9 . Discard the filter. Lubrizol No. 6178 (Lubrizol Corporation). Hi–Tec E–336 (Edwin Cooper, Inc.). Equa–Torque No. 2411 (Sta–Lube Corpora- tion). Equa–Torque No. 2414 (Sta–Lube Corpora- tion). B. For Mobilube HD (mineral oil) and Mobilube SHC (synthetic) use Mobil No. 204 (Mobil Oil Corpora- tion). Add 1.1 ounces [23 mL] of additive for each pint [0.5 L] of lube capacity. IMPORTANT: These friction modifiers generally deteriorate faster than conventional extreme- pressure additives, so the lubricant change schedule must be shortened when using these additives.

The traction equalizer additive (and recommended drive axle lubricant) must be changed at the Maintenance 2 (M2) interval, instead of the Maintenance 3 (M3) interval rec- ommended in the Maintenance Operation Chart for axles that require only those lubricants rec- ommended in Table 2 . f350090a 05/27/93 Fig. 8, Axle Oil Filter Cover Removal and Installation Axle Lubricant and Oil Filter Replacement Procedure 1. With the vehicle parked on level ground, apply the parking brakes, and chock the tires. 2. Remove the axle carrier fill plug ( Fig. 4 ), then remove the drain plug at the bottom of the hous- ing and completely drain the lubricant while the unit is warm.

Allow sufficient time for all old lubri- cant to drain. On tandem drive axles, it is also necessary to remove the plug at the bottom of the interaxle differential housing to drain the lu- bricant. NOTE: There may be about one pint (0.5 L) of lubricant remaining in the filter. Be careful not to spill it when removing the filter. Fig. 9, Axle Oil Filter Removal 3. If so equipped, replace the axle oil filter. Heavy-Duty Trucks Maintenance Manual, January 1997 35/7 05/27/93 f350119