Driveline 41 41–01 Driveline Inspecting Before lubricating driveline U-joints and slip joints, proceed as follows: 1 2 CAUTION 3 Do not over-tighten bearing-cap capscrews or yoke-strap capscrews. Due to the extreme load occurring at high-speed rotation, a loose or bro- ken capscrew at any point in the driveline will weaken the driveline connection, which could eventually result in serious vehicle damage. 4 1. For each full-round driveline yoke with lockstraps (see Fig. 1 , Ref. A) check to be sure the lock- straps are locked. The locking tab must be firmly locked against a flat side of the capscrew head.
If not locked, tighten the bearing-cap capscrew, then bend a tab of the lockstrap upwards until it is firm against a flat side of the capscrew head. 1 1 2 2 A B f410033b 08/13/96 For each full-round driveline yoke with thread- locking capscrews, tighten the bearing-cap cap- screws. See Fig. 1 , Ref. B. A. U-Joint With a Lockplate (for a vehicle built before April 1, 1994). B. U-Joint With Self-Locking Capscrews (for a vehicle built from April 1, 1994). 1. Capscrew (not self-locking) 2. Self-Locking Capscrew 3. Adhesive Band 4. Lockplate For each half-round driveline yoke, tighten the yoke-strap capscrews. See Fig. 2 , Ref. 6.
Tighten all U-joint bearing cap fasteners to the torque values given in Table 1 . Fig. 1, Bearing Cap Capscrews Description Size Torque: lbf·ft (N·m) Fastener Torque Values For torque values, see Group 41 of the Heavy- Duty Trucks Service Manual. If the end yoke is still loose after tightening the yoke nut, replace the yoke and yoke nut. Yoke-Strap Capscrew 1/2–20 130 (176) 5/16–24 24 (33) Replace the prevailing torque locknut (end yoke nut) if it was removed for end yoke replacement, seal replacement, or any other reason. Bearing-Cap Capscrew 3/8–24 37 (50) 7/16–20 60 (81) 3. Check U-joint assemblies for wear by attempting to move the driveshaft up and down, and from side to side.
If movement of the U-joint cross in the bearings can be felt or seen, replace the complete U-joint. Table 1, Fastener Torque Values 2. Check each input and output end yoke (see Fig. 2 ) for cracks and looseness. Replace cracked yokes. 4. Check the midship bearing and mounting for looseness and deterioration by attempting to move the driveshaft up and down, and from side to side. If the bearing is loose on its shaft, or rattles, replace it. If the bearing mount is loose on the frame, tighten the mounting bolt nuts to the applicable torque value in the torque tables in the general information section.
Replace the If any end yoke can be moved in or out on its shaft, or can be rocked on its shaft, disconnect the driveshaft and U-joint from the end yoke, then check the drive component’s shaft seal for leakage or other visible damage that may have been caused by the loose yoke. Replace the seal if needed, then tighten the end yoke nut. Heavy-Duty Trucks Maintenance Manual, April 1998 41/1