Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Driveline 41 1 9 10 2 3 8 2 7 6 11 12 4 5 13 14 15 3 16 05/27/93 f410032a NOTE: Not all fasteners are shown. 1. Full-Round End Yoke 2. Bearing Cap 3. Lockplate and Capscrew 4. Main Transmission 5. Half-Round End Yoke 6. Yoke Strap and Capscrew 7. Slip Joint Assembly 8. Driveshaft Tube 9. Driveshaft Yoke (Full-Round) 10. Input Shaft End Yoke (Half- Round) 11. Splined Shaft 12. Slip Joint Seal Assembly 13. Sleeve Yoke (Full-Round) 14. Yoke Lug 15. U-Joint Cross 16. U-Joint Assembly Fig. 2, Driveline Assembly midship bearing assembly if the rubber cushion is deteriorated or oil-soaked.

0.005 inch (0.127 mm) on the slip-joint-seal sur- face of the splined shaft, 0.010 inch (0.254 mm) on the tube 3 inches (76 mm) from the front and rear welds, and 0.015 inch (0.381 mm) at the center of the tube, replace the tube. See Fig. 4 . 5. Check slip joints for spline wear by attempting to bend the sleeve yoke and splined shaft back and forth. See Fig. 3 . If radial looseness is greater than 0.007 inch (0.18 mm), replace both the sleeve yoke and the splined shaft. If the driveshaft tube requires straightening or replacement, balance the repaired driveshaft be- fore installing it. 6. Visually examine the driveshaft tubes for dents, bends, twists, or other damage.

If any tube ap- pears to be damaged, remove the driveshaft and check the run-out on the tube. If the tube is not straight (and cannot be straightened) within 7. Examine the driveshaft for evidence of missing balance weights, and for build-up of foreign ma- terial. Remove any foreign material. If there is Heavy-Duty Trucks Maintenance Manual, April 1998 41/2