Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Driveline 41 5 1 7 3 4 2 3 f410012a 05/27/93 Attempt to bend the sleeve yoke and splined shaft back and forth. 6 Fig. 3, Slip Joint Spline Wear Checking 8 3 1 A B f410050a 10/20/93 A. After grease appears, cover the pressure-relief hole while continuing to lubricate. 1. Slip Joint Grease Fitting (with grease gun attached) 2. Yoke Plug 3. Grease 4. Half-Round Yoke C C D 5. Yoke Plug Pressure- Relief Hole 6. Slip Joint Seal 7. Full-Round Yoke 8. U-Joint Grease Fitting A. Measurement: 3" (76 mm) B. Measurement: 0.005" (0.127 mm) C. Measurement: 0.010" (0.254 mm) D. Measurement: 0.015" (0.381 mm) f410110b 06/13/96 Fig.

5, Slip Joint and U-Joint Lubricating any evidence that balance weights are missing, remove the driveshaft and have it balanced. Fig. 4, Driveshaft Runout Specifications 2. Use a hand-type grease gun, or a high-pressure gun with a low-pressure adapter, to lubricate U-joints. If a low-pressure adapter is not used with the high-pressure gun, the U-joints may not receive enough grease. 8. For driveshafts with slip joints, check to be sure the yoke plug is not loose or missing. See Fig. 5 , Ref. 2. Repair or replace the yoke plug as needed.

If the yoke plug is missing, the splined shaft may be hitting the plug and knocking it out; contact your Regional Service Office for assis- tance in determining the correct driveshaft length. Using lithium 12-Hydroxy stearate grease (NLGI grade 1 or grade 2, with EP additives), lubricate until new grease can be seen at all four U-joint seals. IMPORTANT: Fresh grease must be seen es- caping from all four bearing-cap seals of each U-joint.

On full-round yokes, if most of the grease being added to a U-joint can be seen escaping from just one of the U-joint seals, bend the tabs of the lockstrap (if equipped) away from the heads of the bearing-cap cap- screws, then check the torque on the capscrews at that seal. Tighten the bearing-cap capscrews 41–02 Driveline Lubricating U-joint Lubricating 1. Wipe all old grease and dirt from each U-joint grease fitting. See Fig. 5 , Ref. 8. Heavy-Duty Trucks Maintenance Manual, April 1998 41/3 A A