Driveline 41 to the torque values given in Table 1 . If equipped, bend the lockstrap tabs up, against a flat side of each capscrew head. If the cap- screws were already tight, or all of the U-joint seals still do not purge, remove the bearing cap at that seal, and examine the seal for damage. If the seal is damaged, replace the complete U-joint. 3. Wipe the purged grease from the pressure-relief hole and slip joint seal, and any excess grease from the grease fitting.
If grease does not appear at one seal, use a screwdriver to pry the U-joint trunnion away from the non-purging seal, or tap the driveshaft or yoke with a plastic or rawhide mallet on the side opposite the dry seal, while continuing to lubricate. If grease still does not appear, bend the tabs of the lockstrap away from the heads of the bearing-cap capscrews, then loosen the capscrews at the bearing with the dry seal, to relieve seal tension. Lubricate the U-joint until new grease is seen at the seal, then tighten the capscrews to the above specifications, and bend the tabs of the lockstrap against a flat side of each capscrew head. If the bearing will not take grease, replace the U-joint.
For U-joint replacement, follow the procedure in Group 41 of the Heavy-Duty Trucks Service Manual. 3. Check the purged grease. If it appears rusty, gritty, or burned, replace the U-joint. 4. Wipe the purged grease from the seals, and any excess grease from the grease fitting. Slip Joint Spline Lubricating 1. Wipe all old grease and dirt from the slip joint grease fitting. See Fig. 5 , Ref. 1. 2. Use a hand-type grease gun or a high-pressure gun with a low-pressure adapter, to lubricate the slip joint. Add multipurpose chassis grease (lithium 12-hydroxy stearate, NLGI grade 1 or grade 2, with EP additives) until it appears at the pressure-relief hole in the yoke plug.
Then cover the relief hole with your finger, while continuing to apply gun pressure until new grease appears at the slip joint seal. See Fig. 5 . This ensures complete lubrication of the splines. Heavy-Duty Trucks Maintenance Manual, April 1998 41/4