Brakes 42 42–01 Brake Adjusting—Cam Brakes With Manual Slack Adjusters A B Meritor Brakes 1. Adjust Meritor brakes whenever the brake cham- ber piston rod applied stroke equals or exceeds the maximum allowable stroke shown in Table 1 . 3 Maximum Allowable Brake Chamber Stroke, with Meritor Cam Brakes 1 2 Chamber Size Effective Area: square inches Maximum Allowable Stroke * : inches (mm) 12 1-1/2 (38) 08/20/93 A. With the brakes released, measure this distance. B. With the brakes applied, measure this distance. 1. Brake Chamber 2. Manual Slack Adjuster (typical) 3. Adjusting Screw f420008a 16 1-3/4 (44) 20 1-3/4 (44) 24 (long stroke) 2 (51) 24 1-3/4 (44) Fig.
1, Measuring Brake Adjustment 30 2 (51) IMPORTANT: On slack adjusters with an adjusting screw locking sleeve, wipe clean the locking sleeve area, and depress the locking sleeve when placing the wrench or socket over the adjusting screw. Do not at- tempt to turn the adjusting screw without fully depressing the locking sleeve. * Adjust the brakes whenever the applied stroke exceeds the maximum. Table 1, Maximum Allowable Brake Chamber Stroke, with Meritor Cam Brakes 1.1 With the brakes released, measure the distance from the face of the air chamber to the centerline of the clevis pin ( Fig. 1 , Ref. A). Record the exact distance as measurement A.
2.2 Turn the adjusting screw until it is tight, then back off the adjustment until the drum is free. Normally, the adjusting screw will need to be backed off 2 or 3 clicks. 1.2 Apply the service brakes and hold them on full line pressure of at least 80 psi (550 kPa). Measure the distance from the face of the brake chamber to the center- line of the clevis pin ( Fig. 1 , Ref. B). Record the exact distance as measure- ment B. NOTE: Check brake adjustment with the wheel on the ground. Checking brake adjust- ment when the wheel is off the ground may be unreliable. Looseness or wear in wheel bearings will cause the drum to be mis- aligned while the wheel is off the ground.
1.3 Subtract measurement A from measure- ment B to determine the applied stroke. 2.3 To determine if the brake drum is free, strike the drum with a steel tool and listen for a clear ringing sound. If a dull thud is heard, the brake is dragging and further adjustment is needed. 2. Compare this value to the maximum allowable stroke value in Table 1 . If the applied stroke equals or exceeds the maximum allowable stroke, adjust the brakes. 2.1 Wipe clean the adjusting screw hexhead. See Fig. 1 . Place a wrench or socket over the adjusting screw hexhead. IMPORTANT: On slack adjusters with an adjusting screw locking sleeve, after adjust- Heavy-Duty Trucks Maintenance Manual, October 2009 42/1