Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 ment, make sure the locking sleeve is en- gaged around the adjusting screw hexhead to lock the adjusting screw in place. 2. Compare this value to the maximum allowable stroke value in Table 2 . If the applied stroke equals or exceeds the maximum allowable stroke, check the piston rod free stroke. Eaton Brakes 2.1 With the brakes released, measure the distance from the face of the air chamber to the centerline of the clevis pin ( Fig. 1 , Ref. A). Record the exact distance as measurement A. 1. Adjust Eaton brakes when either the brake chamber piston rod applied stroke or free stroke equals or exceeds those values in Table 2 . 2.2 Using a lever as shown in Fig.

2 , move the slack adjuster piston rod until the brake shoes contact the drum. Measure the distance from the face of the brake chamber to the centerline of the clevis pin ( Fig. 2 , Ref. B). Record the exact dis- tance as measurement B. Brake Chamber Stroke, with Eaton Cam Brakes Maximum Allowable Stroke * : inches (mm) Chamber Size Effective Area: square inches Desired Free Stroke: inches (mm) 12 1-3/8 (35) 3/8 to 1/2 (10 to 13) 16 1-3/4 (44) 3/8 to 1/2 (10 to 13) 20 1-3/4 (44) 3/8 to 1/2 (10 to 13) B 24 (long stroke) 2 (51) 3/8 to 5/8 (10 to 16) 24 1-3/4 (44) 3/8 to 5/8 (10 to 16) 30 2 (51) 3/8 to 5/8 (10 to 16) * Adjust the brakes whenever the applied stroke exceeds the maximum.

Table 2, Brake Chamber Stroke, with Eaton Cam Brakes 1.1 With the brakes released, measure the distance from the face of the air chamber to the centerline of the clevis pin ( Fig. 1 , Ref. A). Record the exact distance as measurement A. To be allowable, mea- surement A must be within this range: 2-9/16 to 2-11/16 inches (65 to 68 mm). 1 05/27/93 f420010a Measure distance B while prying with a lever. 1. Lever NOTE: If measurement A is outside this range, reposition the clevis. Remove the cle- vis pin, loosen the clevis jam nut, and turn the clevis in or out until measurement A is within the specified range. Then install the clevis pin and tighten the clevis jam nut. Fig.

2 2.3 Subtract measurement A from measure- ment B to determine the free stroke. 3. Compare this value to the desired free stroke value in Table 2 . If the free stroke equals or ex- ceeds this range, adjust the brakes. 1.2 Apply the service brakes and hold them on full line pressure of at least 80 psi (550 kPa). Measure the distance from the face of the brake chamber to the center- line of the clevis pin ( Fig. 1 , Ref. B). Record the exact distance as measure- ment B. 3.1 Wipe clean the adjusting screw hexhead. See Fig. 1 . Position a wrench or socket over the adjusting screw hexhead. IMPORTANT:

On slack adjusters equipped with an adjusting screw locking sleeve, wipe clean the locking sleeve area, and depress the locking sleeve when positioning the 1.3 Subtract measurement A from measure- ment B to determine the applied stroke. Heavy-Duty Trucks Maintenance Manual, October 2009 42/2