Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 wrench or socket over the adjusting screw. Do not attempt to turn the adjusting screw without fully depressing the locking sleeve. Camshaft brackets without grease fittings are fitted with special seals and packed with extended- lubrication-interval chassis grease. Grease them only when the camshaft is disassembled for servicing. 3.2 Turn the adjusting screw until it is tight; then back off the adjustment until the drum is free. Normally, the adjusting screw will need to be backed off 2 or 3 clicks. 1 NOTE: Check brake adjustment with the wheel on the ground. Checking brake adjust- ment with the wheel off the ground may prove to be unreliable.

Looseness or wear anywhere in the wheel bearings will cause the drum to be misaligned while the wheel is off the ground. 3 2 3.3 To see if the drum is free, strike the brake drum with a steel tool and listen for a clear ringing sound. If a dull thud is heard, the brake is dragging and further adjustment is needed. f420011a 05/28/93 A A. Grease Exit. 1. Brake Chamber 2. Slack Adjuster 3. Non-Pressure-Relief Grease Fitting 4. Check the free stroke again to verify that it is within the desired range. Fig. 3, Camshaft Bracket Bushing Lubrication IMPORTANT:

On slack adjusters equipped with an adjusting screw locking sleeve, after adjust- ment, make sure that the locking sleeve is en- gaged around the adjusting screw hexhead to lock the adjusting screw in place. 42–03 Manual/Automatic Slack Adjuster Lubricating and Checking (All Models) 42–02 Camshaft Bracket Bushing Lubricating IMPORTANT: Perform MOP 42–24 before lubri- cating the slack adjusters. Bendix or Sloan Manual Slack Adjuster Lubricating IMPORTANT: Perform MOP 42–24 before lubri- cating the camshaft bracket. Lubricate the slack adjuster with multipurpose chas- sis grease (NLGI Grade 1 or 2). Apply enough grease to completely fill the body cavity.

Brunner or Midland Manual Slack Adjuster Lubricating Pump grease into the camshaft bracket until it ap- pears at the slack adjuster end of the bracket. See Fig. 3 . Multipurpose chassis grease is recom- mended, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease). Be careful that no grease enters the drum cavity. If grease leaks out under the cam head, the camshaft grease seal is worn or dam- aged, or is installed backwards. NOTE: Use of meter-type fittings, which have a maximum 40 psi (275 kPa) pressure relief at shutoff, is recommended. Brunner and Midland slack adjusters are greased for life at assembly.

However, a grease fitting is fur- nished to permit optional lubrication. Heavy-Duty Trucks Maintenance Manual, October 2009 42/3