Brakes 42 Haldex (SAB) Automatic Slack Adjuster Lubricating and Checking 1 2 NOTE: Under normal operating conditions, do not exceed recommended lubrication intervals. Under severe or adverse operating conditions, lubricate more often. 3 1. At (–29°C) and above, lubricate the slack adjusters with any extreme-pressure NLGI Grade 1 or 2 grease, such as Esso Lidoc EP2, Shell Darina No. 1, Texaco Thermotex EP1, or Suna- plex No. 1 EP. Below–20°F(–29°C) use Texaco Low Temp EP or an equivalent. 9 4 8 7 6 WARNING B Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is likely masking a mechanical problem. Adjustment is not repairing.
Before adjusting an automatic slack adjuster, troubleshoot the foundation brake system and inspect it for worn or damaged com- ponents. Improperly maintaining the vehicle brak- ing system may lead to brake failure, resulting in property damage, personal injury, or death. 10/20/93 f420014a A. Rotate the control arm toward the brake chamber until you can feel it contacting the internal stop. B. Rotate the adjusting nut counterclockwise to increase brake shoe clearance. 1. Clevis 2. Slack Adjuster 3. Clevis Pin 4. Manual Adjusting Nut 5. Control Arm A 5 6. Control-Arm Washers and Nut 7. Anchor Strap Slot 8. Anchor Strap 9. Brake Chamber 2.
Inspect each slack adjuster and anchor strap as- sembly for damage. See Fig. 4 . Replace any damaged parts. 3. Check that the control-arm nut is tightened 10 to 15 lbf·ft (14 to 20 N·m). Fig. 4, Haldex (SAB) Automatic Slack Adjuster If the holes in the adjuster and the clevis do not remain aligned, it means the con- trol arm is not against the internal body stop. This indicates an incorrect installa- tion. Move the adjuster into alignment with the clevis hole, and install the clevis pin. Loosen the control-arm nut, and ro- tate the control arm toward the brake chamber until you can feel it contacting the internal stop (see arrow A in Fig. 4 ).
Be sure the control-arm stud moves freely in the slot of the anchor strap. 4. If the control arm is in the wrong position, the brakes will drag. Verify that the control arm is in its full-release position. 4.1 Chock the rear tires, then release the parking brakes. 4.2 Remove the clevis pin. 4.3 With your finger, lightly push the slack adjuster into the clevis, then release it. The adjuster may move slightly due to springing of the anchor strap, but will re- turn to its original position (holes in the adjuster and the clevis will remain in alignment). This shows that the control arm is fully released. CAUTION Do not hammer on the control arm. This may cause internal damage.
4.4 If the control arm is fully released, install the clevis pin and go to the next step. 4.5 Tighten the control-arm nut 10 to 15 lbf·ft (14 to 20 N·m). Heavy-Duty Trucks Maintenance Manual, October 2009 42/4