Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 4.6 Repeat this step to be certain that the control arm is fully released. Final operat- ing travel is obtained after the vehicle has been driven and the brakes are heated. 1 NOTE: Brake shoe clearance can be in- creased for inspection or brake system ser- vicing by turning the manual adjusting nut counterclockwise (see arrow B in Fig. 4 ). Turning it in that direction takes considerable effort and may be accompanied by a ratch- eting sound. 2 3 4 Meritor Automatic Slack Adjuster Lubricating and Checking 5 7 6 WARNING f420012a 10/20/93 1. Brake Chamber 2. Clevis 3. Actuator Rod 4. Boot 5. Pressure-Relief Capscrew, Gasket, Pawl Spring, and Pawl 6. Manual Adjusting Nut 7.

Grease Fitting (or Lube Plug) Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is likely masking a mechanical problem. Adjustment is not repairing. Before adjusting an automatic slack adjuster, troubleshoot the foundation brake system and inspect it for worn or damaged com- ponents. Improperly maintaining the vehicle brak- ing system may lead to brake failure, resulting in property damage, personal injury, or death. Fig. 5, Meritor Automatic Slack Adjuster is not repairing. Before adjusting an automatic slack adjuster, troubleshoot the foundation brake system and inspect it for worn or damaged com- ponents.

Improperly maintaining the vehicle brak- ing system may lead to brake failure, resulting in property damage, personal injury, or death. 1. Lubricate the slack adjuster using high- temperature, waterproof grease, NLGI Grade 1, such as Texaco Thermotex EP No. 1, Shell Da- rina No. 1, Marathon 528 heavy-duty, Sunaplex No. 1 EP, Amdex No. 1 EP, or Philube B No. 1. It should be smooth-textured, corrosion-resistant grease, free of fillers and abrasives. Lubricate the slack adjuster through the grease fitting ( Fig. 5 , Ref. 7) until grease is forced out past the pressure-relief capscrew (Ref. 5), or past the gear splines around the inboard snap ring. 1.

Lubricate the slack adjuster until grease flows from the grease relief opening. See Fig. 6 . For temperatures to (–40°C), use Lubriplate Aero; for temperatures to (–29°C), use Texaco Multifak EP–2 or MobilGrease No. 77. The newest Gunite slack adjusters are produced without a grease relief. During lubrication with a grease gun, lubricant is forced through the drilled worm wheel onto the camshaft. Lubricate the slack adjuster at the grease fitting until grease appears on the camshaft. 2. Check the boot for cuts, tears, or other damage. Replace it if necessary. Gunite Automatic Slack Adjuster Lubricating and Checking 2. Inspect the slack adjuster for structural damage.

Replace the slack adjuster if needed. WARNING 3. Inspect the slack adjuster boot for cuts or tears. Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is likely masking a mechanical problem. Adjustment If the boot is damaged, replace it as follows (see Fig. 6 ). 3.1 Remove the two clevis pins. Heavy-Duty Trucks Maintenance Manual, October 2009 42/5