Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 Install the 1/4-inch clevis pin and the cot- ter pin. 3.6 Tap the clevis upward or downward until the large hole in the slack adjuster lines up with one in the clevis. 4 5 6 Install the 1/2-inch clevis pin and the cot- ter pin. 7 3 8 WARNING Make sure both clevis pins are installed. Failure to do so will cause the slack adjuster to work incor- rectly, which could lead to loss of braking control. This could result in an accident causing personal injury or property damage. 2 9 1 42–04 Meritor Automatic Slack Adjuster Lubricating 10 IMPORTANT: Perform MOP 42–24 before lubri- cating the slack adjusters. 1. Remove the pressure-relief capscrew, pawl spring, and pawl. See Fig. 5 .

10/27/93 1. 7/16-Inch Adjusting Nut 2. Grease Fitting 3. Boot 4. Link 5. Brake Chamber Piston Rod 6. Clevis 7. 1/2-Inch Clevis Pin 8. 1/4-Inch Clevis Pin 9. Grease Relief Opening 10. Slack Adjuster Spline f420653a 2. Examine the pawl for grease retention and condi- tion. If the grease is in good condition, install the pressure-relief capscrew, pawl spring, and pawl; then tighten the pressure-relief capscrew 15 to 20 lbf·ft (20 to 27 N·m). Lube the slack adjuster through the grease fitting until lubricant is forced out through the pressure-relief fitting (or pawl slot). Fig.

6, Gunite Automatic Slack Adjuster 3.2 Rotate the worm shaft adjusting hexnut counterclockwise to move the link away from the clevis. About 45 lbf·ft (60 N·m) is needed. You will hear a clicking sound. If the grease has hardened, or the pawl is dry and shows extreme wear, remove the slack ad- juster. Disassemble and clean it. Inspect the in- ternal parts, install new seals and a new boot when assembling, then install and lubricate the slack adjuster. See Group 42 of the Heavy-Duty Trucks Service Manual for instructions. 3.3 Install a new boot on the link, heavy sec- tion down. Be careful not to damage the boot. Remove the old boot from the link.

3.4 Seat the boot so that the bottom of the boot is in the boot insert, and the top is in the groove of the link. 42–05 Wedge Brake Checking 1. Check brake shoe lining wear to determine the proper reline time. 3.5 Rotate the adjusting hexnut clockwise until the 1/4-inch hole in the clevis lines up with the hole in the link. 2. Check the lining-to-drum clearance. Automatic adjusters are working properly if (for brakes using two parking brake chambers per wheel) clearance at the inspection hole is between Heavy-Duty Trucks Maintenance Manual, October 2009 42/6