Brakes 42 0.010 and 0.060 inch (0.25 and 1.5 mm). If ad- justers are not working properly, schedule the vehicle for brake system service. See Group 42 of the Heavy-Duty Trucks Service Manual. 5 6 7 For brakes using one parking brake chamber per wheel, clearance in excess of 0.035 inch (0.9 mm) may require manual adjustment to obtain optimum performance, until the vehicle can be scheduled for service. 3 4 8 The above numbers are established as a guide (to indicate a range) only, and are not precise. Specific situations may differ due to individual component combinations of drums and linings, etc. 2 1 3. Check service and parking brake air systems by cycling the respective application valves.
f350020a 10/20/93 1. Adjusting Plunger 2. Hollow Capscrew 3. Gasket 4. Pawl Spring 5. Adjusting Pawl 6. Adjusting Bolt 7. Plunger Seal 8. Adjusting Sleeve Check the service brake by actuating the treadle several times. Observe the action to determine if there is correct actuating system function, and correct lining-to-drum contact. Check parking brake operation by actuating the control valve on the dashboard of the cab. Fig. 7, Wedge Brake Adjusting Components NOTE: Highly polished parts do not always re- quire replacement. Only components that are scored or show other unusual signs of wear must be replaced. 42–06 Wedge Brake Inspecting and Lubricating 4.
Grease the unit using multipurpose chassis grease, NLGI grade 1, such as Texaco Thermo- tex EP No. 1, Shell Darina No. 1, Marathon 528 heavy-duty, Sunaplex No. 1 EP, Amdex No. 1 EP, or Philube B No. 1. Assemble the adjusting plunger, replace the seal (using an appropriate seal driver), and assemble the pawl. Then, manually adjust the brake to specifications. IMPORTANT: Before inspection, cage all parking brake units manually or by air pressure. See Group 42 of the Heavy-Duty Trucks Service Manual for instructions. Ensure that the emer- gency brake airline pressure is exhausted be- fore removing the line from the brake chamber. 1. Remove the wheels and brake drums.
Refer to the axle section in the service manual for wheel and drum removal instructions and brake lining dust warnings. 42–07 Alcohol Evaporator Checking 2. Inspect the plunger seals. See Fig. 7 . If seals are cut, torn, or otherwise ineffective, disas- semble and overhaul the brake actuating components. Bendix NOTE: During freezing weather, check the alco- hol evaporator weekly. 3. Remove the pawl assembly, then remove the adjusting plunger and seal, to check internal con- dition. If grease is contaminated or hardened, or if parts are dry, disassemble and overhaul the brake actuating components.
Check that all fittings are tight, and that bubbles are present in the alcohol when the compressor is com- pressing. See Fig. 8 . If the alcohol evaporator is not operating properly, see the troubleshooting guide in Group 42 of the Heavy-Duty Trucks Service Manual. Heavy-Duty Trucks Maintenance Manual, October 2009 42/7