Brakes 42 6. Install the cover tetraseal. 7. Install the reservoir on the cover and tighten the capscrews. 8. Fill the reservoir with 40 ounces (1183 mL) of methyl alcohol, then install the filler cap. 1 42–08 Bendix Alcohol Evaporator Cleaning If a strainer is present, check that it is clear. See Fig. 8 . Clean or replace the strainer if necessary. 42–09 Bendix Alcohol Evaporator Gasket Replacing f420005a 01/06/95 1. Strainer Fig. 8, Bendix Alcohol Evaporator (sectional view) Disassemble the evaporator and the check valve (if so equipped). Clean all parts, and replace all gaskets and rubber parts.
Midland Maintenance is required during both the freeze sea- son and the off season to keep the alcohol evapora- tor in good working order. Off Season 42–10 Bendix Air Dryer Checking (AD–2, AD–4, or AD–9) During the off season, drain the unit of alcohol. At regular engine service intervals, open the drain cock to remove moisture from the alcohol evaporator. Be- fore reactivating the evaporator for the next freeze season, drain, disassemble, inspect, and steam- clean the unit of any sludge that may have accumu- lated. It is advisable to replace any rubber parts when assembling the alcohol evaporator. Perform this service just before the freeze season.
Freeze Season Reactivation Bendix AD–2 Check operation of the heater and thermostat. This can be done by allowing the end cover assembly to cool below 50°F (10°C), then placing your hand near the end cover when the ignition switch is turned on. The end cover should be warm to the touch within a few minutes. Warming should cease at about 85°F (30°C). Bendix AD–4 1. Remove the filler cap, and check the cap tet- raseal. Check the operation of the end cover heater-and- thermostat assembly during cold weather. 2. Remove the capscrews and reservoir from the cover. 1. With the ignition or engine control on, check for power at the dryer’s electrical terminal, using a voltmeter or test light.
Check between the electri- cal terminal and the metal end cover. If there is no voltage, look for a blown fuse, broken wires, or corrosion in the vehicle wiring harness. 3. Remove the cover tetraseal. 4. Drain the air tank, and disconnect the line from the evaporator outlet. Remove the check-valve retainer, spring, and disc. 5. Install the disc, spring, and check-valve retainer, and connect the line to the evaporator outlet. 2. Turn off the ignition switch and cool the end cover assembly to below 40°F (4°C). Heavy-Duty Trucks Maintenance Manual, October 2009 42/8