Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Steering 46 WARNING shut down the engine and install a new reservoir cover gasket. Fill only with approved clean fluid. Do not mix fluid types. Any mixture or any unapproved fluid could lead to seal deterioration and leaks. Fluid leakage could cause loss of power steering assist, possibly resulting in personal injury and property damage. 13. Check the power steering fluid level in the reser- voir. If the fluid level is low, add more of the same fluid used above to bring the level up to the full mark on the dipstick. 46–07 Steering Driveline Deck Bearing Lubricating, FLA/FLB 7. Fill the reservoir with approved power steering fluid. See Table 1 . IMPORTANT:

Do not start the engine while draining the system. For an FLA or an FLB, apply light oil sparingly to the deck bearing. Apply the oil at the deck bearing sup- port cap (if equipped), or through the felt seal on top of the deck bearing support bracket. 8. Place the disconnected end of the steering gear- to-reservoir hose in a drain bucket. Raise the front of the vehicle with a floor jack and support it with jack stands. Have someone turn the steer- ing wheel to full lock left and right, and capture the fluid flowing from the hose in the drain bucket. Add fluid to the reservoir as needed. Continue turning the steering wheel until clean power steering fluid flows from the hose into the drain bucket.

46–08 TRW Power Steering Gear Lubricating, TAS Series 9. Remove the caps (as applicable) from the ports and fitting. For a 3-line system, remove the fitting from the pump-to-reservoir hose and attach it to the reservoir port. Connect the hose(s) to the reservoir. Tighten each hose fitting nut finger- tight, then tighten with a wrench until resistance is felt. Tighten one-sixth turn more. Do not over- tighten. 1. Wipe off debris from the grease fitting. See Fig. 11 . Remove the jack stands and lower the vehicle. 10. Fill the reservoir with the same fluid used above, as needed. Start the engine and let it idle.

Have someone turn the steering wheel to full stop in each direction until no bubbles are seen in the reservoir. Shut down the engine. 1 11. Install the cover and capscrew on the reservoir. Tighten the capscrew 10 to 15 lbf·ft (14 to 20 N·m). If equipped with a thumbscrew, install the cover and thumbscrew, and tighten the thumb- screw finger-tight. For a 9-quart reservoir, install a new O-ring, the band clamp, and the cover. Tighten the clamp bolts 40 lbf·ft (54 N·m). 04/13/93 1. Sector Shaft Grease Fitting f460515a Fig. 11, TRW TAS Series Sector Shaft Lubricating Install the dipstick. 2.

Using a hand-type grease gun, apply multipur- pose chassis grease until grease starts coming out of the sector shaft dirt and water seal. 12. Start the engine. Check the reservoir for fluid leaks around the cover. If fluid leaks are present, Heavy-Duty Trucks Maintenance Manual, November 2002 46/5