Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Fuel 47 47–01 Fuel Tank Vent Checking 2 1 On earlier vehicles with a screw-on fuel cap, remove the fuel cap and clean it with solvent. Make sure the fuel cap vent is open. Install the cap. On vehicles with a quarter-turn fuel cap, check to be sure the vent line at the inboard side of the fuel tank is clean and not plugged. 3 47–02 Fuel Tank Band Nut Tightening, FLA, FLB, and FLD 3 Hold each fuel tank band retention nut with a wrench while backing off its jam nut. Then tighten the reten- tion nuts 30 to 45 lbf·ft (41 to 60 N·m). After the re- tention nuts have been tightened, hold each with a wrench while tightening its jam nut 50 to 65 lbf·ft (68 to 88 N·m). Do not overtighten.

4 5 47–03 Fuel Separator Sight Bowl Cleaning and Element Replacing 6 ConMet Fuel Separator Sight Bowl Cleaning 7 8 The only maintenance necessary on ConMet fuel separators is to clean the sight bowl, if equipped. See Fig. 1 . 9 10 WARNING 08/25/95 f470146 Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 1. Vacuum Breaker/Drain Valve 2. Reducer Bushing 3.

Mounting Brackets 4. O-Ring (when equipped with heater) 5. Stainless Steel V-Clamp (when equipped with heater) 6. Heater Assembly 7. Gasket 8. Sight Bowl Heater Rod 9. Sight Bowl Assembly 10. Vacuum Breaker/Drain Valve 1. Drain the fuel separator. 2. Unscrew the sight bowl from the fuel separator. Fig. 1, ConMet Fuel Separator 3. Wipe the sight bowl clean using a soft cloth. 4. Lubricate the gasket with a film of oil, and rein- stall it on the sight bowl. If the gasket appears dry-rotted or damaged, replace the gasket. Heavy-Duty Trucks Maintenance Manual, October 1997 47/1