Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Fuel 47 5. Lightly lubricate the threads on the sight bowl with oil, then thread the sight bowl into the bot- tom of the fuel separator. 1 1 6. Hand-tighten until the gasket is in full contact with the fuel separator, then tighten an additional 1/4 to 1/3 turn. 12 2 7. Check that the drain valve is tightened and closed. 8. Prime the fuel separator. 9 8.1 Remove the vacuum breaker fitting and fill the unit with diesel fuel. 8.2 Install and close the vacuum breaker fit- ting when the unit is full of fuel. 10 10 11 3 9 1 3 IMPORTANT: The fitting must be air-tight and the valve closed.

Racor Fuel Separator Element Replacement 2 The only service necessary on Racor fuel separators is to replace the filter element. See Fig. 2 . Racor 325R and 330R 4 WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 5 6 1. Disconnect the water sensor probe connector, if equipped. 7 8 2.

Place a suitable container under the fuel heater/water separator, then drain the fuel from the fuel heater/water separator by opening the drain valve. 05/28/97 f470194 1. Mounting Hole 2. Mounting Head 3. Heater Connector 4. Filter Element 5. Collection Bowl 6. Water Sensor 7. Water Sensor Connector 8. Drain Valve 9. Vacuum Switch Connector 10. Vacuum Switch 11. Fuel Outlet 12. Fuel Inlet 3. Remove the filter element and collection bowl together, by turning the filter element off of the mounting head. 4. Remove the filter element from the collection bowl by turning the collection bowl; then discard the filter element. Fig.

2, Racor 325R Fuel Heater/Water Separator (330R similar) Heavy-Duty Trucks Maintenance Manual, October 1997 47/2