Fuel 47 5. Remove and discard the bowl O-ring; then clean the bowl of debris using diesel fuel only. Clean the bowl O-ring seat with a shop cloth. 1 2 6. Lubricate the new bowl O-ring with clean diesel fuel or motor oil; then seat it into the collection bowl. 3 3 7. Attach the collection bowl to a new filter element, hand-tight. Do not use tools. 8. Lubricate the new filter element square-cut gas- ket with clean diesel fuel or motor oil. 9. Fill the filter and bowl assembly with clean diesel fuel. 4 4 5 5 1 10. Spin the filter and bowl assembly onto the mounting head until the gasket contacts the head base; then turn it an additional 1/3 to 3/4 of a turn. 6 6 2 11.
Connect the water sensor probe connector if equipped. 4 4 12. Start the engine and check for fuel leaks. Repair all fuel leaks with the engine OFF. Racor 460R 7 WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 8 11 9 1. Disconnect the water sensor probe connector, if equipped. See Fig. 3 . 05/28/97 f470261 10 2. Disconnect the bowl heater connector, if equipped.
1. Mounting Head 2. Vent Plug 3. Fuel Outlet 4. Fuel Inlet 5. Fuel Priming Pump 6. Mounting Hole 7. Filter Element 8. Collection Bowl 9. Water Sensor Probe 10. Fuel Heater Wire 11. Drain Valve 3. Place a suitable container under the fuel heater/water separator, then loosen the vent plug and drain the fuel from the fuel heater/water separator by opening the drain valve. Fig. 3, Racor 460R Fuel Heater/Water Separator 4. Remove the filter element and collection bowl together, by turning the filter element off of the mounting head. 6. Remove and discard the bowl O-ring; then clean the bowl of debris using diesel fuel only. Clean the bowl O-ring seat with a shop cloth. 5.
Remove the filter element from the collection bowl by turning the collection bowl; then discard the filter element. 7. Lubricate the new bowl O-ring with clean diesel fuel or motor oil; then seat it into the contaminant bowl. Heavy-Duty Trucks Maintenance Manual, October 1997 47/3