Fuel 47 8. Attach the collection bowl to a new filter element, hand-tight. Do not use tools. 2 9. Lubricate the new filter element square-cut gas- ket with clean diesel fuel or motor oil. 3 1 10. Spin the filter and bowl assembly onto the mounting head until the gasket contacts the head base; then turn it an additional 1/3 to 3/4 of a turn. 4 11. Connect the water sensor probe connector if equipped. 11 12. Connect the bowl heater connector if equipped. 13. Loosen the vent plug, then operate the primer pump until the fuel purges at the vent plug. Then close the vent plug. 5 10 14. Start the engine and check for fuel leaks. Repair all fuel leaks with the engine OFF.
Racor 490R 9 6 7 WARNING 06/25/97 f470147 8 Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 1. Mounting Head 2. Fuel Primer Pump 3. Metal Vent Plug 4. Bowl O-Ring 5. Bowl Bevel-Cut Gasket 6. Bowl Probe Plug 7. Water Sensor Probe 8. Heater Connector 9. Bowl Drain Valve Assembly 10. Bowl with Drain and Water Sensor 11. Service Element Fig. 4, Racor 490R Fuel Separator 1.
Drain off some fuel by loosening the vent plug and opening the drain valve. See Fig. 4 . 8. Prime the fuel separator. 8.1 Loosen the vent plug. Then operate the primer pump until the fuel purges at the vent plug. 2. Disconnect the water sensor and heater connec- tions, if equipped. 3. Remove the element and bowl, together, by turn- ing counterclockwise. 8.2 Close the vent plug. 9. Start the engine and check for fuel leaks. 4. Remove the bowl from the element, and clean the O-ring. 10. Shut down the engine and correct any fuel leaks. Racor 690R and 6120R 5. Apply a coating of clean fuel or motor oil to the new O-ring and element seal. 6.
Spin the bowl onto the new element, then spin them both onto the filter head snugly, by hand only. WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- IMPORTANT: Do not use tools to tighten. 7. Connect the water sensor and heater connec- tors, if equipped. Heavy-Duty Trucks Maintenance Manual, October 1997 47/4