Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Fuel 47 age. When working on a fuel system, have a fire extinguisher within easy reach. 6. Spin the bowl onto the new element, then spin them both onto the filter head snugly, by hand only. 1. Drain off some fuel by loosening the vent plug and opening the drain valve. See Fig. 5 . IMPORTANT: Do not use tools to tighten. 7. Connect the water sensor and heater connec- tors, if equipped. 8. Prime the fuel separator. 8.1 Remove the 3/8-inch metal plug located at the top of the fuel/water separator (see Fig. 5 , Ref. 2), and manually fill the unit with diesel fuel. 8.2 Install and tighten the 3/8-inch metal plug when the unit is full. 10. Shut down the engine and correct any fuel leaks.

Racor 900FG and 1000FG 9. Start the engine and check for fuel leaks. WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 1. Remove the lid by turning the T-handle. See Fig. 6 . 09/15/95 f470148 1. Mounting Head 2. Metal Plug, 3/8" NPT 3. Bowl O-Ring 4. Bowl Bevel-Cut Gasket 5. Bowl Probe Plug 6. Water Sensor Probe 7. Heater Connector 8. Bowl Drain Valve Assembly 9.

Bowl with Drain and Water Sensor 10. Service Element 2. Remove the filter element by raising the handle built into the filter element; then carefully turn the filter element while lifting up. 3. Remove and discard the lid gasket; then replace it with and new one. Fig. 5, Racor 690R Fuel/Water Separator (6120R Similar) 4. Lubricate the lid gasket with clean diesel fuel; then seat it into the lid. 2. Disconnect the water sensor and heater connec- tions, if equipped. 5. Fill the unit with clean diesel fuel. 6. Install the lid; then tighten it hand-tight, or to 10 lbf·ft (14 N·m). 3. Remove the element and bowl, together, by turn- ing counterclockwise. 4.

Remove the bowl from the element, and clean the O-ring. 7. Start the engine and check for fuel leaks. Repair all fuel leaks with the engine OFF. 5. Apply a coating of clean fuel or motor oil to the new O-ring and element seal. Heavy-Duty Trucks Maintenance Manual, October 1997 47/5 1 10 9 8 2 3 4 5 6