Exhaust 49 49–01 Exhaust System Inspecting (Noise Emission Control) 4. If leakage exists, tighten the nut on the V-band coupling 85 lbf·in (940 N·cm). If leakage persists, install a new V-band coupling. 5. Inspect the turbo outlet pipe, and replace it as needed. Pre-EPA07 Exhaust System Inspecting 6. Check the U-bolt clamps for tightness, and tighten as needed. 7. Check for leakage at all wide-band exhaust clamps. See Fig. 2 , Fig. 3 , or Fig. 4 . In addition to inspecting the exhaust system at the scheduled maintenance interval, inspect the exhaust system if the noise level of the vehicle has in- creased. Replace parts that show leakage, wear, or damage, with genuine Freightliner parts.
If leakage exists, tighten the nuts 40 to 60 lbf·ft (54 to 81 N·m). If leakage persists, install a new wide-band exhaust clamp. Do not re-use Donald- son Seal Clamps. 1. On all vehicles, check the condition of the muffler body, top stack, or top stack silencer. Check the inlet/outlet tubes for leakage, dents, and corro- sion, and check for holes in the muffler. Replace parts as required. Use new parts, equivalent to parts originally installed on the vehicle. See Group 49 of the Heavy-Duty Trucks Service Manual for replacement procedures. 2. Inspect the exhaust flex hose (see Fig. 1 ) for leakage, wear, or damage. Replace with new parts if replacement is needed. 3.
Check for leakage at the V-band coupling that attaches the exhaust pipe to the turbocharger exhaust outlet. See Fig. 1 . f490025a 05/28/93 Fig. 2, Donaldson Seal Clamp Wide-Band Exhaust Clamp 2 1 3 4 06/01/93 1. Flex Hose 2. V-Band Coupling 3. Exhaust Pipe 4. Turbocharger Exhaust Outlet f490024a f490023a 05/28/93 Fig. 1, V-Band Coupling and Flex Hose Fig. 3, Riker Tru-Seal Wide-Band Exhaust Clamp Heavy-Duty Trucks Maintenance Manual, January 2007 49/1