Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Exhaust 49 Inspection 1. Check for leakage at the clamp that attaches the exhaust pipe to the turbocharger exhaust outlet. If leakage exists, tighten the nut on the clamp to the required torque. If leakage persists, install a new clamp. 2. Check the exhaust pipe, bellows, and each ex- haust seal clamp for leakage, wear, cracks, or damage. Replace damaged components as needed. If leakage exists at a clamp, tighten the nuts to the required torque. If leakage persists, install a new exhaust seal clamp. Do not reuse seal clamps. Once a seal clamp is loosened or removed, it must be replaced. f490005a 10/05/94 Fig. 4, Torca Torctite Wide-Band Exhaust Clamp EPA07 Exhaust System Inspecting 3.

If present, check the condition of the insulation material around the exhaust pipe between the turbocharger and the ATD. 4. Check the ATD mounting bands for tightness. Tighten to 30 lbf·ft (41 N·m) if needed. Do not overtighten. IMPORTANT: The Environmental Protection Agency’s 2007 regulations require lower ex- haust emissions, thus requiring new exhaust system components. See Fig. 5 . In particular the after-treatment device (ATD), which is part of the after-treatment system (ATS), requires special attention during regularly scheduled maintenance inspections. If any discrepancies are discovered, refer to the engine manufactur- er’s service literature for repair instructions. 5.

Check for leaks around the clamps that attach the ATD in the ATS, and around the clamps that retain the DPF in the ATD. No leaks are allowed anywhere in the system. 6. Check all sensors attached to the ATD for leaks or damaged wires. No leaks are allowed. 7. Check the DPF exterior surface for dents or other damage. See Item A of Fig. 5 . A dent over 3 inches (76 mm) in diameter and 1/4-inch (6- mm) deep could cause internal damage to the DPF, causing it to malfunction. Definitions of ATS Components Refer to the following list of definitions of ATS com- ponents. 8. Check for heat discoloration on the surface of the ATD. Heat discoloration may indicate internal damage; especially around the DPF.

After-Treatment System (ATS)—the entire ex- haust system from the turbocharger to the ex- haust stack or tail pipe. 9. Check any wires, lines, or hoses within 4 inches (10 cm) of the exhaust system for heat damage. Repair or reroute as needed. After-Treatment Device (ATD)—a muffler-like canister that houses a DPF, DOC, and sensors. Diesel Particulate Filter (DPF)—a filter that col- lects and holds particulate matter (soot and ash). Diesel Oxidation Catalyst (DOC)—oxidizes hy- drocarbons and reduces NOx. Sensors—detect temperatures and pressures in the ATS. Heavy-Duty Trucks Maintenance Manual, January 2007 49/2