Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Electrical, Instruments, and Controls 54 54–01 Electrical System Checking NOTE: Tighten electrical system connections to the torque values in Table 1 . Torque Values for Electrical System Connections Connection Torque: lbf·in (N·cm) Electrical Panel Stopnut 30 (340) Air/Oil Junction Block Ring-Terminal Nut 30 (340) Battery Terminal 70 (800) Main Cab-Power Stud Hexnut 175 (1980) Main Cab-Ground Stud Hexnut 50 (560) Table 1, Torque Values for Electrical System Connections Cab Interior f540592a 10/20/93 Fig.

1, FLA Electrical Mounting Plate Inspect the wiring and electrical connections at the electrical mounting plate, cab-to-chassis interface connectors, cab-to-engine interface connectors, main cab-power and cab-ground studs, and electrical junc- tion blocks. For an FLA, see Fig. 1 and Fig. 2 . For an FLB, see Fig. 3 and Fig. 4 . For an FLC (LH DR), see Fig. 5 and Fig. 6 . For an FLD, see Fig. 7 . For an FLC (RH DR), see Fig. 8 and Fig. 9 . For an FLA, uncover the electrical mounting plate by removing the tunnel top cover. The cover is held in place by Velcro ® . Pull upward on the left front and rear corners, then tip the cover up and to the right.

Uncover the electrical junction block by removing the tunnel right-hand kick panel. Fig. 2, FLA Electrical Junction Block For an FLB, uncover the electrical mounting plate by removing the tunnel left-hand cover. See Fig. 10 , Ref. 3. Loosen the quarter-turn fastener (Ref. 2) at the lower rear edge of the cover, then pull back on the cover to unfasten the Velcro. and manifest box (Refs. 8 and 10). Then pull the cover upward between the seat and tunnel. For an FLC (LH DR), uncover the main cab connec- tors and studs by removing the right-hand under- dash cover. See Fig. 11 , Ref. 1. Uncover the electri- cal mounting plate by opening the glove box (Ref.

2), then moving the stops at the upper edge of the box toward each other, while swinging the glove box down and out of the dash. Remove the tunnel right-hand cover (Ref. 7) by mov- ing the passenger seat up and back, removing the screw (Ref. 4) at the upper left edge, and removing the two screws (Ref. 6) at the lower right edge. Pull the cover right and back, to clear the combo cover Heavy-Duty Trucks Maintenance Manual, April 1998 54/1 05/28/93 f540040a