Electrical, Instruments, and Controls 54 4 3 2 5 1 1 f540607 07/20/95 Fig. 5, FLC (LH DR) Electrical Mounting Plate 10/20/93 NOTE: Before March 15, 1990, the main cab harness interface connectors were located on the firewall. f540276a 1. Junction Block 2. Main Cab-Power Studs (circuit 14 studs on junction block) 3. Relays 4. Circuit Breaker Bus Bar 5. Cab-to-Chassis and Cab-to-Engine Harness Interface Connectors 1 2 3 Fig. 7, FLD Electrical Mounting Plate straps may cause breaks in the wire insulation, allowing the aluminum tie strap to make contact with the wire. This could cause a short circuit and damage to the wiring. 5 4 2. Check all tie straps for breakage and damage.
Replace any broken or cracked tie straps. 08/24/93 f540629 3. Check the wires of all sensors on or near the engine. Make sure no wires are closer than 6 inches (15 cm) to hot surfaces. If any are, and can not be rerouted, make sure they are pro- tected by heat shields. Check that sensor con- nectors are tight, clean, and undamaged. 1. Bottom of Dash 2. Main Cab-Power Stud (Red) 3. Main Cab Harness Interface Connector 4. Main Cab-Ground Stud 5. Right-Hand Side of Firewall (Inside Cab) Fig. 6, FLC (LH DR) Main Cab Harness Connectors 4. On engines with electronic controls, check the wiring and connectors on the computer units. heat. Also check for kinks.
Reroute, repair, or replace wires as needed. CAUTION Do not use flat-strip aluminum tie straps for hold- ing electrical wiring. The sharp edges on these tie Heavy-Duty Trucks Maintenance Manual, April 1998 54/3 LH HDLP RH HDLP HTR CONT COMP CLT SHTR SHTDN 15 15 15 PNL LP MKR LP RH HDLP 10 30 5 A/C HTR HT/AC 5 5 5 FUEL VH FAN Q HTR HI X LOAD 15 10 WIPER MID MIR 10 10 10 RADIO ACCESS AIR DRY 10 5 STG AID INSTR 15 15 20 LH HDLP CIG LT RD LP 30 20 20 TR BRN DIR SIG SI LP 30 15 5 TR BLK HORN CLOCK 1A 1B 1 ACC ACC 2A 2B 2C TRLR BRN MKR LP TRLR BLK PNL LP 3A 3B 3 PNL LP GND 4A 4B 4